GFW148SSMWW
23 7/16" 25 5/8"
42 13/16"
®
GE
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
2.4 DOE Cu. Ft. Frontload Washer with Steam
INS TA LLATI O N IN F O RMATI O N: For complete information,
see installation instructions packed with your washer.
12-13/16"
33 1/4"
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
33 1/4"
Speci fication Created 8/18
GFW148SSMWW
®
GE
STAC KED I NSTAL L ATIO N :
- Kit for stacking dryer over washer is not included with the washer.
Order part no. GFA24KITL
ALCOVE OR CLOSET INSTALLATION:
- If your dryer is approved for installation in an alcove or closet, it will be
stated on a label on the dryer back.
- The dryer MUST be exhausted to the outside with the exception of the
condensing dryer.
- Minimum clearances between dryer cabinet and adjacent walls or other
surfaces are: 1" left and right sides, 1" top, 3" front and rear.
- Minimum clearances between washer cabinet and adjacent walls or other
surfaces are: 1" left and right sides, 1" top, 1" front and rear..
- Closet doors must be louvered or otherwise ventilated and must contain a
minimum of 60 sq. in. of open area equally distributed. If this closet contains
both a washer and a dryer, doors must contain a minimum of 120 sq. in. of
open area equally distributed.
- No other fuel-burning appliance shall be installed in the same closet with a
ga s d r yer.
BATHROOM OR BEDROOM INSTALLATION:
- The dryer MUST be exhausted to the outdoors with the exception of the
condensing dryer.
- The installation must conform with the local codes, or in the absence of
local codes, with the National Electric Code and National Fuel Gas Code,
ANSI Z223 for gas dryers.
MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET
INS TA LLATI O NS:
- Minimum clearances to combustible surfaces 0" both sides, 3" rear.
FOR MORE INFORMATION ON VENTING KITS AND ACCESSORIES,
PLEASE CALL 1-800-GE-CARES.
2.4 DOE Cu. Ft. Frontload Washer with Steam
66 1/2"
STACKED DIMENSIONS (IN INCHES)
23 7/16" 25 5/8"
3 3/8"
20 1/2"
33 1/4"
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
Speci fication Created 8/18
GFW148SSMWW
®
GE
INSTALLATION INFORMATION
PLATFORM REQUIREMENTS TO MEET THE GUIDELINES
FOR THE AMERICANS WITH DISABILITIES ACT (ADA)
FABRICATE A WOODEN PLATFORM FOLLOWING THESE
REQUIRED INSTRUCTIONS
FOR ADA COMPLIANCE:
1. The platform must raise the appliance at least 3", but not more than 7".
2. A hardwood fascia board that is 1" thick is required on any open side
3. The suggested maximum distance between lateral supports is 10".
4. Plywood top must be 3/4" thick.
5. The platform length can be dimensioned to fit one or multiple front
6. The platform must be firmly secured, at least at two points, to an
7. Place the front loading compact laundry unit(s) on the completed
platform.
8. The front of any front loading compact laundry unit must be less than 10"
9. Follow the Installation Instructions shipped with your washer and/or
2.4 DOE Cu. Ft. Frontload Washer with Steam
of the platform. The fascia board must have a lip height of 1" above the
top to allow the consumer to open the front clean-out panel. Each fascia
board must be attached with minimum of six 1/4" - 20 x 4" bolts with
fender washers and locknuts on the backside.
loading compact laundry units.
adjacent wall.
from the front of the platform including the fascia board.
dryer to complete the installation.
Front loading compact washer shown mounted on the wooden
platform which is secured to adjacent wall
QUESTIONS? CALL 800.GE.CARES (800.432.2737)
OR VISIT OUR WEB SITE AT: GEAPPLIANCES.COM
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
Speci fication Created 8/18
GFW148SSMWW
®
GE
FEATURES AND BENEFITS
Stainless steel basket – Long-lasting stainless steel finish resists rust and
won’t chip, peel or snag clothes
Steam – Penetrates deep into fabric fibers, loosening stains like tomato
and grass, yet protects your fabrics
ENERGY STA R® qualified – Meets or exceeds federal guidelines for
energy efficiency for year-round energy and money savings
Electronic touch controls – Enjoy easy operation and cleanability with
streamlined controls
14 wash cycles – Multiple cycles are designed to specifically handle various
fabrics and soils
1400 RPM spin speed – Fast spin speeds remove water efficiently and
minimize dry time
Inlet fill hoses included
Quick Wash – Provides a quick wash for lightly soiled items that are
needed in a hurry
Internal water heater – Increases wash temperature to reduce bacteria and
provide better cleaning for the really tough stains
2.4 DOE Cu. Ft. Frontload Washer with Steam
Model GFW148SSMWW – White on white
Speci fication Created 8/18
Loading...