General Dynamics Itronix IX-4965AGN, IX-GUBTC41MTH User Manual

Page 1 of 3

Duo-Touch® II Help

Identification

Duo-Touch II (IX350)

Copyright Notice

© 2007 Copyright General Dynamics Itronix Corporation. All rights reserved. No part of this document may be reproduced,
transmitted, transcribed, stored in a retrieval system, or translated into any other language or computer language in whole or in part, in
any form or by any means, whether it be electronic, mechanical, magnetic, optical, manual, or otherwise, without the prior written
consent of General Dynamics Itronix Corporation, 12825 E. Mirabeau Parkway, Spokane Valley, WA 99216.

Disclaimer

This document is created in the U.S.A. General Dynamics Itronix reserves the right to revise the manual and make perio dic chan ges to
the content without a direct or inferred obligation to notify any person of such revision or changes. Gen e ral Dy namics Itronix does not
assume responsibility for the use of this help manual, nor for any patent infringemen ts or ot her rights or th ird part ies who may use the
manual.

This document contains valuable trade secrets and proprietary information of General Dynamics Itronix.
This product is available for purchase under General Dynamics Itronix's standard terms and conditions of sale. General Dynamics

Itronix hardware products may be reconditioned, or be manufactured from parts and components that may be new, used, rebuilt, or
recycled and, in some cases, the hardware product may not be new and may have been previously installed. In any event, General
Dynamics Itronix warranty terms apply.

Trademark and Patent Notice

Itronix is a registered trademark of General Dynamics Itronix.
Duo-Touch is a registered trademark of General Dynamics Itronix.
Microsoft, MS Windows, and MS-DOS are registered trademarks of Microsoft Corporation.
IBM is a trademark of International Business Machines Corporation.

The following United States Patent Numbers apply to any unit which incorporates a DVD drive - 5,434,678; 5,589,945; 5,913,013;
6,151,444; and 6,208,805.

Compliance Statements

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules .
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna.

•

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

FCC CAUTION

To assure continued compliance, (example - use only shielded interface cables when connecting to computer or peripheral devices)
any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE

2/28/2008file://C:\DOCUME~1\harwoodm\LOCALS~1\Temp\247MWIH0.htm

Page 2 of 3

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Local Restriction of 802.11a/b/g/n Radio Usage

CAUTION

countries, 802.11a/b/g/n products are designed for use only in specific countries, and are not allowed to be operated in countries other
than those of designated use. As a user of these products, you are responsible for ensuring that the products are used only in the
countries for which they were intended and for verifying that they are configured with the correct selection of frequency and channel
for the country of use. Any deviation from permissible settings and restrictions in the country of use could be an infringement of
national law and may be punished as such.

Due to the fact that the frequencies used by 802.11a/b/g/n wireless LAN devices may not yet be harmonized in all

FCC Radio Frequency Interference Requirements

This device is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency range. FCC requires this product to be
used indoors for the frequency range 5.15 to 5.25 GHz to reduce the potential for harmful interference to co-channel Mobile Satellite
systems. High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations
can cause interference with and /or damage this device.

REN

The Duo-Touch II (IX350) computer complies with Part 68 of the FCC Rules. On the bottom of this equipm ent is a label th at contains,
among other information, the FCC registration number and ringer equivalence number (REN) for this equipment. If requested, this
information must be provided to the telephone company.

The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the telephone
line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of the RENs should not
exceed five (5.0). To be certain of the number of devices that may be connected to the line, as determined by the total RENs, contact
the telephone company to determine the maximum REN for the calling area.

The Duo-Touch II (IX350) computer may be connected to the telephone network using the RJ-11 jack provided.
If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary

discontinuance of service may be required. If advance notice isn’t practical, the telephone company will notify the customer as soon as
possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.

The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of the
equipment. If this happens, the telephone company will provide advance notice in order for you to make the necessary modifications in
order to maintain uninterrupted service.

If trouble is experienced with this equipment, please contact the equipment manufacturer for repair and/or warranty information. Do
not attempt repairs of this equipment yourself without obtaining manufacturer authorized parts and documentation. If the tro ubl e is
causing harm to the telephone network, the telephone company may request you remove the equipment from the network until the
problem is resolved.

Compliance Statement for Canada

NOTICE

telecommunications network protect i ve, operational and safety requirements as prescribed in the appropriate Terminal Equipment
Technical Requirements document(s). The Department does not guarantee the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection. The customer should
be aware that compliance with the above conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be made by a representative designated by the supplier. Any repairs or alterati ons made by the
user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect
the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility , telephone lines, and internal
metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.

CAUTION!

authority, or electrician, as appropriate.

The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain

Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection

The Ringer Equivalence Numbers (REN) are:
Duo-Touch II (IX350) non-radio: 0.5B

2/28/2008file://C:\DOCUME~1\harwoodm\LOCALS~1\Temp\247MWIH0.htm