4096-630
May 29, 2007
ASSEMBLY MANUAL
Revision H
1.2M Ku-BAND Rx/Tx
SERIES 1132
ANTENNA SYSTEM
General Dynamics Satcom Technologies
1500 Prodelin Drive
Newton NC 28658USA
Phone 828-464-4141
www.gdsatcom.com
1.2M Ku-BAND Rx/Tx
SERIES 1132 ANTENNA SYSTEM
H General Revision 5-29-07 RAH
G Revised for removal of indicator and scale 5/19/05 RF
F Del 0185-492 add 0185-491 12/16/04 RAH
E Revised Az/El to 0185-492 10/12/04 RAH
D Revised for new reflector 9/3/2003 CLT
C Revised text on page 14 8/26/02 CLT
B Revised Diagrams and Text 1/25/02 CLT
Revised Address
A
- ORIGINAL RELEASE 3/14/01 CLT
REV. DESCRIPTION DATE APPROVED
1/9/02 RAH
4096-630
General Dynamics Satcom Technologies 1.2M Ku-BAND Rx/Tx SERIES 1132
2
4096-630
General Dynamics Satcom Technologies 1.2M Ku-BAND Rx/Tx SERIES 1132
TABLE OF CONTENTS
SECTION TITLE
I INTRODUCTION
1.0 GENERAL INFORMATION
1.1 UNPACKING & INSPECTION
1.2 FREIGHT DAMAGE
1.3 MATERIAL MISSING OR DAMAGED
1.4 MECHANICAL INSTALLATION TOOLS
1.5 FOUNDATION INTERFACE
II ANTENNA SYSTEM ASSEMBLY
2.0 REFLECTOR & SUPPORT ASM PART LIST
2.1 ANTENNA ASSEMBLY
2.2 FEED SUPPORT PART LIST
2.3 FEED SUPPORT ASSEMBLY
III SATELLITE ALIGNMENT
3.0 ANTENNA POINTING
IV MAINTENANCE
4.0 MAINTENANCE OVERVIEW
4.1 REFLECTOR
4.2 MOUNT & REFLECTOR SUPPORT
4.3 FEED & FEED SUPPORT
3
4096-630
General Dynamics Satcom Technologies 1.2M Ku-BAND Rx/Tx SERIES 1132
SECTION I INTRODUCTION
1.0 GENERAL INFORMATION
This manual describes the assembly and installation of General Dynamics's 1.2
meter antenna system. The General Dynamics 1.2 meter is a rugged and reliable
mount which will operate in the Ku-Band frequency with high efficiency and at the
same time successfully withstand the effects of the environment. The General
Dynamics 1.2 meter has an f/d ratio of .8 and an offset angle of 17.30°. This
system is commonly used with a General Dynamics 39° feed horn.
These instructions are listed by sections that cover all areas of assembly and
installation. Additional sections are included in the manual to provide information
on antenna alignment to the satellite and maintenance.
1.1 UNPACKING AND INSPECTION
The system containers should be unpacked and inspected at the earliest date to
insure that all material has been received and is in good condition. A complete
packing list for each major component is supplied.
1.2 FREIGHT DAMAGE
Any damage to materials while in transit should be immediately directed to the
freight carrier. He will instruct you on matters regarding any freight damage
claims.
1.3 MATERIAL – MISSING OR DAMAGED
Any questions regarding missing or damaged materials that are not due to the
freight carrier should be directed to General Dynamics's Customer Service
Department at:
General Dynamics Satcom Technologies
1500 Prodelin Drive
Newton NC 28658
(828) 464-4141
USA
4
Loading...