General Air Products H2hOme Installation Manual

1

2

3

4

Remove the bolts on both sides of base plate. Loosen clamps on cam fitting & disconnect hose.

Slide the right side of pump assembly out first using
the handles on the sides of the base plate.

Continue to pull the pump assembly out by the base
plate handles & disconnect the test hose.

Pump Assembly Removal

The H2hOme pump assembly can be easily removed for
transporting and servicing the unit. The following instructions
describe how to remove/reinstall the pump assembly and
riser manifold kit. For full instructions regarding installation,
operation and maintenance procedures, please refer to the
H2hOme manual.

PUMP ASSEMBLY REMOVAL &

INSTALLATION INSTRUCTIONS

TM

1

2

3

4

Using the handles on base, slide the left side of pump
assembly into the tank opening & connect test hose.

Position the pump assembly so the slots in the base

line up with the nuts on both sides.

Install the hose & lock the clamps on cam fitting. Install the bolts on both sides of base plate.

Thread the riser into manifold and tighten until riser is in an upright position.

Pump Assembly Installation

Riser Installation