Genelec S360-424B Instruction Manual
Instruction manual
1. Scope of delivery
2. Usage &
3. Mounting
2.1
Direct mounting
2.1.a - Ceiling mount
2.1.b - Wall mount -horizontal
2.1.c - Wall mount -vertical
&
Mounting (see fig.):
3.1 Preparations (drill holes)
3.1.a Installation sample
2.2 - Ceiling mount holders
2.3 - Wall Mount holder
&
Mounting (see fig.):
3.2 & 3.3 - Parts assembly
2.4 - Ceiling mount plate
&
Mounting (see fig.):
3.4 - Parts assembly
Further applications:
2.5 - Truss mount holder
2.6 - Eye bolt hang
S360-424B Top-bottom mounting bracket for GENELEC S360
Please check if all the components
are there and o.k.
1.1 - washers ø 10,5/21 mm (2x)
1.2 - hexagon head screws M10 x 30 mm (2x)
1.3 - caps SW17 (2x)
1.4 - rubber discs ø 9,5/54 mm (2x)
1.5 - flange nuts M6 (2x)
1.5 - &
1.6 - U-bracket
1.7 - adaptor plate
3.1.a
Installation sample for concrete ceilings/walls:
Hammer in 4 bolt anchors M10 x 95 mm, install the
U-bracket, place the washers and tighten the nuts
3.1
Place the U-bracket (1.6),
mark the drill holes,
drill all 4 drill holes,
blowout the drill holes
3.4
Bolt the U-bracket (1.6) to
the ceiling mount plate (2.4)
which also contains the
screw set (2.4.a)
3.2 / 3.3
Bolt the
U-bracket (1.6)
per adaptor (1.7)
to the fixing
bracket of the
holder. Use two
flange nuts (1.5).
There are three
mounting options:
x - y- z
4. Monitor mounting 6. Dimensions
Safety instructions
Bolt together monitor S360
with the U-bracket (1.6)
4.1 In case remove the
covering caps of the
S360 - insert nuts.
4.2 Place the rubber discs (1.4)
between the lateral brackets
and the monitor S360
4.3 Use two screws
M10x30mm (1.2) with
washers (1.1) and caps (1.3).
PER MOUNTING BRACKET, directly:
5.1.a Continuously tiltable
5.1.a up to 30 & 330°-360° depen-
5.1.a ding on the chosen hole (1 or 2)
5.1.a and the dimension of the fixing
5.1.a bolts (5.1.1)
5.1.b Loosen the two
5.1.b hex screws (1.2) a little
5.1.c Tilt the monitor into the
5.1.c desired position and
5.1.c retighten the hex screws (1.2)
PER INSTALLATION ACCESSORY,
here: S360-444B wall mount (2.3)*
5.2.a Continuously rotatable (ß°)
5.2.a only by manual force.
5.2.a Choose hole 1,2 or 3.
5.2.b Hold the monitor safely while
5.2.b adjust the tilting angle and
5.2.b tighten wall mount screw.
5.2.c Continuously tiltable (x-y-z)
5.2.c from horizontal up to -30°,
5.2.c given by wall mount.
* further accessories see 2. Usage (2.2 -2.6)
Weight: 3.1 kg
GENELEC Oy
Olvitie 5, Fin-74100 Iisalmi, www.genelec.com
24468-000-56 Rev.06 03-80-910-00 11/18
S360-424B Top-bottom mounting bracket for GENELEC S360
e.g.: ceiling mount, directly w/o installation accessories
e.g.:
with
install.
access.:
wall
mount
S360444B
5. Monitor adjusting
- For GENELEC S360
- Check for damage prior to and after use. Damaged mounts may not be used again.
- Not suitable for outdoors or moist rooms.
- Observe the local mounting regulations (they may deviate from the examples presented here).
- Only mount on suitable walls or ceilings with the corresponding assembly material (not included in the
- delivery). Not suitable are fragile walls or ceilings. Beware of power supply lines and water conduits.
- In case ask an expert.
- Only use trained technicians to assemble the system.
- Ensure that the screws are tight and load-bearing, in particular as regards the setting of the
- loudspeaker angle.
- Inspect bolted assemblies periodly
- The placement of the loudspeakers requires two physically fit qualified technicians.
- Careful and attentive handling is required when tilting the monitor and also adjusting the installation
- assemblies - due to the possibility of pinching or wedging your hand.
- External influences such as bumping into the loudspeakers, brushing into the loudspeakers, things
- thrown at the loudspeaker, wind etc. represent a risk and must be avoided. Measures: Compliance
- with safety distances, keeping unauthorized persons at a distance, if needed put safety cordons.
- Please observe also enclosed document GENERAL SAFETY & MOUNTING NOTES
- The instructions provide directions to all of the important setup and handling steps. We recommend,
- you keep these instructions for future reference.
MOUNTING POSITIONS in combination with a Ceiling- or Truss mount
800-436B/W
K&M 24486-000-5x
Mounting
Position 1
Mounting
Position 2
Mounting
Positions
1, 2, 3, 4
Mounting
Position 3
Mounting
Position 4
Mounting
Position 1
800-442B/W
K&M 24491-000-5x
800-444B/W
K&M 24494-000-5x
800-446B
K&M 24499-000-55
S360-424B Top-bottom mounting bracket for GENELEC S360
Loading...