No part of this publication may be reproduced, stored in a retrieval system, or
transmitted in any form or by any means, whether electronic, mechanical,
photocopying, recording, or otherwise without the prior written consent of the
publisher.
Printed in Taiwan, April 2002
IMPORTANT INFORMATION
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Shielded VGA cable must be used in order to comply with emission limits.
FCC Caution: To assure continued compliance, (example - use only shielded
interface cables when connecting to computer or peripheral devices). Any
changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
IMPORTANT NOTE:
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 20 centimeters between the radiator and
your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
2
R&TTE Compliance Statement
This equipment complies with all the requirements of the DIRECTIVE
1999/5/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL of 9
March 1999 on radio equipment and telecommunication terminal Equipment
and the mutual recognition of their conformity (R&TTE).
The R&TTE Directive repeals and replaces in the directive 98/13/EEC
(Telecommunications Terminal Equipment and Satellite Earth Station
Equipment) As of April 8, 2000.
Safety
This equipment is designed with the utmost care for the safety of those who
install and use it. However, special attention must be paid to the dangers of
electric shock and static electricity when working with electrical equipment. All
guidelines of this manual and of the computer manufacturer must therefore be
allowed at all times to ensure the safe use of the equipment.
EU Countries intended for use
The ETSI version of this device is intended for home and office use in Austria,
Belgium, Denmark, Finland, France (with Frequency channel restrictions),
Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway,
Portugal, Spain, Sweden, Switzerland and United Kingdom.
The ETSI version of this device is also authorized for use in EFTA member
states Iceland, Liechtenstein, Norway and Switzerland.
EU Countries Not intended for use
None.
Potential restrictive use
France: Only channels 10,11,12, and13
3
Safety Notification
Your Wireless Presentation Gateway should be placed in a safe and secure
location. To ensure proper operation, please keep the unit away from water
and other damaging elements.
Please read the installation guide thoroughly before you install the
Wireless Presentation Gateway.
The Wireless Projector should be repaired by authorized and qualified
personnel only
Please do not try to open or repair the Wireless Presentation Gateway
yourself.
Do not place this product in a damp or humid environment, e.g. in a
bathroom.
The Wireless Presentation Gateway should be placed in a sheltered and
non-slippery location within a temperature range of +5 to +40 Celsius
degree.
Please do not expose the Wireless Presentation Gateway to direct
sunlight or other heat sources. The housing and electronic components
may be damaged by direct sunlight or heat sources.
4
TABLE OF CONTENTS
1. Introduction………….………………………………………………………… 7
2. Hardware Installation ………………………………………………………….8
3. WPG11 Web Configuration ………. …………………………………………10
4. EPS player Program .…….……………………………………………………14
5. Troubleshooting.………..…………………………………………………..….20
6.Specifications……………………………………………………………………21
5
1. INTRODUCTION
1.1 Congratulation on Your Purchase of the Wireless
Presentation Gateway
The Wireless Presentation Gateway features state of the art technology that
helps bring wireless capability to a conventional projector. You can now
access the projector through a wireless network effortlessly without being
constrained by the physical layout of a wired connection.
The Wireless Presentation Gateway allows for multiple dynamic wireless
connections from several PCs. The benefit of using Wireless Presentation
Gateway is therefore enormous. Image -- a user can join an ongoing
presentation session at any time and wait for his turn to do a short
presentation over the projector. When presentation is no longer required, he
can simply log off and leave the presentation group without much disturbance.
WPG11 is therefore, your perfect option for a company conference, and other
occasions (many people)
1.2 Getting Started
This user’s manual will assist you with the installation procedure. Please take
a few minutes now to review the complete manual before getting started. This
can save you much time and trouble later. In the later sections, the Wireless
Presentation Gateway is sometimes abbreviated as WPG11. Both terms will
be used interchangeably hereafter.
1.3 What’s in the Box?
The package you have received should contain the following items:
Wireless Presentation Gateway
User’s Manual (the document you are now reading)
Power Adapter
Note: If any piece is missing, please contact your dealer.
6
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.