Page 1
DX-WGNBC_WGDTC.fm Page 1 Monday, June 12, 2006 10:34 PM
Wireless Enhanced G NB Card
Product Name [French]
Product Name [Spanish]
DX-WGPNBC
US E R G U I D E • G U I D E DE L’ U T I L I S ATEU R • G U Í A D E L U S U A R I O
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Federal Communication Commission Interference Statement
SAR compliance has been established in typical laptop computer(s) with CardBus slot, and
product could be used in typical laptop computer with CardBus slot. Other application like
handheld PC or similar device has not been verified and may not compliance with related RF
exposure rule and such use shall be prohibited.
Dynex declares that DX-WGPNBC ( FCC ID: MXF-P950602G ) is limited in CH1~CH11 for 2.4
GHz by specified firmware controlled in U.S.A.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
FCC & IC Radiation Exposure Statement:
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Page 8
IC statement
IC statement
Operation is subject to the following two cond itions:
1) This device may not cause interference and
2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Page 9
Loading...