GemTek Technology M950606AG User Manual

WMIA-166AG(R)

User’s Guide

11A/G mini PCI module

FCC Statement

FCC Caution: Any changes or modifications not expressly
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:

l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and

receiver.

approved by the party responsible for compliance could void the

user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause

undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set

forth for an uncontrolled environment. This equipment should be

installed and operated with minimum distance 20cm between

the radiator & your body.

This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

l Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

l Consult the dealer or an experienced radio/TV technician

for help.

This device is intended only for OEM integrators under the

where the antenna may be installed such that 20 cm may be

following conditions:

1) The antenna must be installed such that 20 cm is

maintained between the antenna and users, and

2) The transmitter module may not be co-located with any

other transmitter or antenna, and

3) The antenna should be integral if the end device is intended

to be operated in 5.15 ~ 5.25GHz frequency range.
As long as 3 conditions above are met, further transmitter test
will not be required. However, the OEM integrator is still
responsible for testing their end-product for any additional
compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements,
etc.).
IMPORTANT NOTE: In the event that these conditions can not
be met (for example certain laptop configurations or co-location
with another transmitter), then the FCC authorization is no
longer considered valid and the FCC ID can not be used on the

maintained between the antenna and users (for example :
Access point, Router… mobile device.). The final end product
must be labeled in a visible area with the following: “Contains
TX FCC ID: MXF-M950606AG”.

Manual Information That Must be Included

The OEM integrator has to be aware not to provide information
to the end user regarding how to install or remove this RF
module in the users manual of the end product which integrate
this module.
The users manual for end users must include the following
information in a prominent location “ IMPORTANT NOTE: To
comply with FCC RF exposure compliance requirements, the
antenna used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must
not be co-located or operating in conjunction with any other
antenna or transmitter”.

If the end product integrating this module is going to be
final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization.

End Product Labeling

This transmitter module is authorized only for use in device

operated in 5.15 ~ 5.25GHz frequency range, the warning

statement in the user manual of the end product should include

the restriction of operating this device in indoor could void the

user’s authority to operate the equipment.