GemTek Technology C921217G User Manual

WL-611GS

User’s Guide

802.11g Wireless LAN PC Card

FCC Statement

FCC Caution: Any changes or modifications not expressly
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and

receiver.

approved by the party responsible for compliance could void the

user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause

undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set

forth for an uncontrolled environment.

This device complies with FCC RF Exposure limits set forth for

an uncontrolled environment, under 47 CFR 2.1093 paragraph

(d)(2).

This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.
 Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician

for help.

Gemtek Technology Co., Ltd declares that WL-611GS (FCC ID:

MXF-C921217G) is limited in CH1~CH11 by specified firmware

controlled in U.S.A.

EC DECLARATION OF CONFORMITY (EUROPE)

Gemtek Technology Co., Ltd. declares that the device conform

Table of Contents

to the specifications listed below, following the provisions of the
European R&TTE directive 1999/5/EC, EMC directive
89/336/EEC, and Low Voltage directive 73/23/EEC:
For 2.4 GHz devices with 100 mW radios, the following
standards were applied:

• ETS 300-826, 301 489-1 General EMC requirements for
Radio equipment.

• EN 609 50 Safety

• ETS 300-328-2 Technical requirements for Radio equipment.

Caution: This equipment is intended to be used in all EU and
EFTA countries. Outdoor use may be restricted to certain
frequencies and/or may require a license for operation.
Contact local Authority for procedure to follow.

Introduction……………………………………………..1

A Look at the Hardware……………………………….2

Hardware Installation………………………………….3

Configuration……………………………………..…….4