
Installation
Instructions
Free-Standing Side-by-Side
Stainless Steel Refrigerator
ZFSB23D SS
ZFSB25D SS
monogram.com

Safety Information
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT– Save these instructions
for local inspector’s use.
• IMPORTANT – Observe all governing
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions with
your Owner’s Manual for future reference.
WARNING:
This appliance must be properly grounded. See
“Grounding the Refrigerator,” page 4.
AVERTISSEMENT :
Cet appareil doit être correctement mis à la terre.
Consulter « Mise à la terre du réfrigérateur », page 4.
If you received a damaged refrigerator, you should
immediately contact your dealer or builder.
Skill Level – Installation of this refrigerator requires
basic mechanical, carpentry and plumbing skills.
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the GE Appliance Warranty. See the
Owner’s Manual for warranty information.
CAUTION:
Due to the weight and size of this refrigerator, and to
reduce the risk of personal injury or damage to the
product – TWO PEOPLE ARE REQUIRED FOR PROPER
INSTALLATION.
PRUDENCE :
À cause du poids et de la taille de ce réfrigérateur et
pour réduire le risque de blessure et de dommages,
IL FAUT DEUX PERSONNES POUR FAIRE L’INSTALLATION
CORRECTEMENT.
WARNING:
• Use this appliance only for its intended purpose.
• Immediately repair or replace electric service cords
that become frayed or damaged.
• Unplug the refrigerator before cleaning or making
repairs.
• Repairs should be made by a qualified service
technician.
AVERTISSEMENT :
• Il ne faut utiliser cet appareil que pour l’utilisation
appropriée.
• Réparer ou remplacer immédiatement tout cordon
électrique effiloché ou endommagé.
• Il faut débrancher le réfrigérateur avant le nettoyage
ou toute intervention.
• Les réparations doivent être faites par un technicien
qualifié.
CONTENTS
Planning Information
Product Dimensions and Clearances............................................3
The Installation Space..........................................................................3
Installation Instructions
Tools, Hardware, Materials ................................................................4
Grounding the Refrigerator ..............................................................4
Step 1, Move Refrigerator Indoors (ZFSB25) ............................5
Step 1A, Move Refrigerator Indoors (ZFSB23) ............................6
Step 2, Install Water Line ..................................................................7
Step 2A, RO Water Line ......................................................................8
For Monogram local service in your area, call
1.800.444.1845.
For Monogram service in Canada, call
1.800.561.3344
For Monogram Parts and Accessories, call
1.800.626.2002.
www.monogram.com
tep 3, Connect W
S
Step 4, Connect Power ........................................................................8
Step 5, Move Refrigerator Into Position ......................................8
tep 6, Lev
S
Step 7, Level Doors ..............................................................................9
Step 8, Screw Down Support Leg ..................................................9
tep 9, Start Icemaker ......................................................................10
S
Step 10, Temperature Controls......................................................10
Step 11, Install Toekick......................................................................10
el Refrigerator ..................................................................9
ater Supply ........................................................8
2

Planning Information
36"
72"
29-1/2"
Including
Handles
27-1/2"
Case
Depth
19"
14-1/4"
160° Door Swing
72"
36"
30-1/2"
Including
Handles
28-1/2"
Depth
Wall View
Electrical
Area
73" min.
Water Supply
36-1/4" min.
PRODUCT DIMENSIONS AND CLEARANCES
ZFSB23
These Monogram free-standing refrigerators require the
following clearances for proper air circulation, plumbing
and electrical connections.
Air Circulation Clearances:
• 1/8" on each side
• 1" at the top
• 1-1/2" at the back side
THE INSTALLATION SPACE
The opening width must be at least 36-1/4".
ZFSB25
Installation in a corner:
• Allow 4" clearance on each side to an adjacent wall for a
90° opening and access to drawers.
ALL MODELS
ZFSB25
ZFSB23
• On the freezer side, allow 14-1/4" min. clearance
for removal of ice bin.
On the fresh food side, allow 19" min. clearance
•
all for removal of drawers.
to w
er And Electrical Locations
at
W
The opening must be prepared with the electrical and water
supply located as shown.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is required.
An individual properly grounded branch circuit or circuit
eaker is recommended. Install a properly grounded
br
3-prong electrical receptacle recessed into the back wall.
NO
TE:
ound fault interr
GFI (gr
upter) is not recommended.
• Water line can enter the opening through the floor or
through an adjacent cabinet, as close to the back
wall as possible. The water line should be GE
Smar
tConnect
™
efrigerator T
R
ubing or 1/4" O
. copper
.D
tubing between the cold water line and water connection
location at the rear of the refrigerator. Installation of an
easily accessible shut off valve in the water line is
recommended.
3

Installation Instructions
TOOLS REQUIRED
• Tinsnips to cut banding
Stepladder
•
• Bucket
• Level
• Appliance hand truck
• Tubing cutter
• #2 Phillips screwdriver
• Drill and appropriate bits
• 3/8", 5/16" and 7/16" hex socket
• 1/8" Allen wrench
• Safety glasses
MATERIALS REQUIRED
• 1/4" O.D. compression nut and 2 ferrules (sleeves)
OR GE SmartConnect™Refrigerator Tubing Kits
GROUNDING THE REFRIGERATOR
IMPORTANT – (Please read carefully)
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
The power cord of this appliance is equipped with
a 3-prong (grounding) plug which mates with a
standard 3-prong (grounding) wall receptacle to
minimize the possibility of electric shock hazard
from this appliance.
FLOORING
For proper installation, this refrigerator must be placed on
level surface of hard material that is at the same height
a
as the rest of the flooring. This surface should be strong
enough to support a fully loaded refrigerator.
IMPORTANT NOTE: Protect the finish of the flooring. Cut a
large section of the cardboard carton and place under the
refrigerator where you are working.
DO NOT, UNDER ANY
CIRCUMSTANCES, CUT
OR REMOVE THE THIRD
(GROUND) PRONG
FROM THE POWER CORD.
DO NOT USE AN ADAPTER PLUG TO CONNECT THE
REFRIGERATOR TO A 2-PRONG OUTLET.
Have the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
properly grounded.
Where a standard 2-prong wall outlet is encountered,
it is your personal responsibility and obligation to
have it replaced with a properly grounded 3-prong
wall outlet.
DO NOT USE AN EXTENSION CORD WITH THIS
APPLIANCE.
4