GE Monogram ZBD4700XWW User Manual

™

Monogram.



ZBD4700XWW—Dishwasher with stainless steel interior

Dimensions and Specifications (in inches)

23 3/8"

Design Information: This dishwasher is supplied as
a white model.

5 1/2"

This dishwashers has a finished door and access
panel. The door and access panel trim will accept
custom panels up to 1/4" thick.

34" Min.

35" Max.

A toekick is supplied and may be covered with a
custom toekick to match kitchen decor.

Side trim is not required. Side filler strips are supplied
to fill a 24" wide opening.

Additional Specifications: A 120 Volt, 60 Hz power

4"

supply is required. An individual properly grounded
branch circuit protected by a 15 or 20 amp circuit

25 1/4"
From Inside
Front Frame

22 5/8"

breaker or time delay fuse is recommended. Install a
3-prong electrical receptacle at least 6" above the
floor and within 18" of the right or left adjacent
cabinet wall. Wiring must enter the cutout in shaded
area shown. A double, side-by-side installation
requires two separate circuits.

The hot water line must enter the cutout in the shaded
area from the right, left, rear or through the floor. The
water line should be 3/8" O.D. copper or 1/2" O.D.
plastic. Installation of an easily accessible hand
shut-off valve is strongly recommended.

Revised 7/97

Toekick

34" Min.

35" Max.

Underside of

Countertop

to Floor

3 3/16"

This Wall Area

Must be Free of

Pipes or Wires

1-3/4"

Plumbing and Electric Service

Must Enter Inside This Area

23-5/8" Min.

24" Max.

24"

Min.

6"

The dishwasher should be placed no more than 10
feet from the sink for proper drainage.

If the dishwasher is to be located in or near a corner
of base cabinets, allow 2" min. clearance from the
corner to prevent interference with adjacent door
handles.

For answers to your GE Monogram,™GE Profile,

™

GE, Hotpoint and RCA appliance questions, call
GE Answer Center®service, 800.626.2000.

L

Listed by
Underwriters
Laboratories

U

R

™

Monogram.



ZBD4700XWW—Dishwasher with stainless steel interior

Dimensions and Specifications (in inches)

1/4" Custom Door and Access Panel Dimensions

Notch 1/8"

Cut 1/4" thick door panel: 23-1/4" wide, 22-11/16" high.

3/16"

Cut 1/4" thick access panel: 23-1/4" wide 1-1/2" high.
Cut edges of the panels will be concealed by the trim.

5/16"

Radius

Cut

1/4" Thick

Door Panel

1/4" Thick Access Panel

23 1/4"

22 11/16"

1 1/2"

Cut a notch in the top corners of the door panel. 1/8"
wide and 3/16" deep. This will allow the panel to slide
under the escutcheon. The bottom corners of the door
panel trim and all 4 corners of the access panel trim
are rounded. Therefore, for a good fit, a 5/16" radius
cut is required.

Revised 7/97

For answers to your GE Monogram,™GE Profile,
GE, Hotpoint and RCA appliance questions, call
GE Answer Center®service, 800.626.2000.

L

Listed by
Underwriters
Laboratories

U

R

™