Gemini MOBILE PAK201 Setup Manual

Worldwide Headquarters • 120 Clover Place, Edison, NJ 08837 • USA

Tel: [phone] • Fax: [phone]

France • G.S.L. France • 11, Avenue Leon Harmel, Z.I. Antony, 92160 Antony, France

Tel: + 33 (0) 1 55 59 04 70 • Fax: + 33 (0) 1 55 59 04 80

Germany • Gemini Sound Products GmbH • Liebigstr. 16, Haus B - 3.0G 85757 Karlsfeld, Germany

Tel: 08131 - 39171-0 • Fax: 08131 - 39171-9

UK • Gemini Sound Products • Unit C4 Hazleton Industrial Estate, Waterlooville, UK P08 9JU

Tel: [phone] • Fax: [phone]

Spain • Gemini Sound Products S.A. • Rosello, 516, Barcelona, Spain, 08026

Tel: [phone] • Fax: [phone]

© Gemini Sound Products Corp. 2003 All Rights Reserved.

Parts of the design of this product may be protected by worldwide patents.

Information in this manual is subject to change without notice and does
not represent a commitment on the part of the vendor. Gemini Sound
Products Corp. shall not be liable for any loss or damage whatsoever
arising from the use of information or any error contained in this manual.

No part of this manual may be reproduced, stored in a retrieval system or
transmitted, in any form or by any means, electronic, electrical, mechanical,
optical, chemical, including photocopying and recording, for any purpose
without the express written permission of Gemini Sound Products Corp.

It is recommended that all maintenance and service on this product is
performed by Gemini Sound Products Corp. or its authorized agents.

Gemini Sound Products Corp. will not accept liability for loss or damage
caused by maintenance or repair performed by unauthorized personnel.

In the USA: If you experience problems with this unit,

call 1-732-738-9003 for Gemini Customer Service.

Do not attempt to return this equipment to your dealer.

SETUP GUIDE

MOBILE PAK

201

®

INTRODUCTION

Congratulations on purchasing the GEMINI MOBILE PAK 201 DJ Kit. Each piece of equipment
comes with instructions packed into the unit box. Prior to use, we suggest that you carefully read
the individual unit instructions included with your equipment.

DJ KIT FEATURES:

• One CDX-602 Instant Start Frame Accurate Dual CD Player with Pitch Control

• One PMX-1100 Four Channel Stereo Preamp Mixer

• MRC-2 Road Case

• RCA Cables

CAUTIONS:

1. All operating instructions should be read before using this equipment.

3. To reduce the risk of electrical shock, do not open the units. There are NO USER REPLACEABLE
PARTS INSIDE. Please refer servicing to a qualified service technician.

4. Do not expose units to direct sunlight or to a heat source such as a radiator or stove.

5. The units should be cleaned only with a damp cloth. Avoid solvents or other cleaning detergents.
Do not use any spray cleaner or lubricant on any controls or switches.

6. When moving this equipment, it should be placed in its original carton and packaging. This will
reduce the risk of damage during transit.

7. Do not expose these units to rain or moisture.

NOTE: EXCESSIVE VOLUME CAN CAUSE DAMAGE TO YOUR STEREO SYSTEM AND SPEAKERS. KEEP VOLUME AT A

REASONABLE LEVEL.

CONNECTIONS:

Before making any connections, make sure all of the units have the power off. Before plugging in
the power cords, make sure that the VOLTAGE SELECTOR on the CD player is set to the correct
voltage (refer to the cd player instructions for more detail).

MRC-2:

Open the MRC-2 case and place the CDX-602 main unit inside the case. Next place the remote
control and PMX-1100 mixer on the top section of the case and use the provided hardware
to attach the gear to the case.

CD PLAYERS TO MIXER:

1. On the rear of the CD player are two sets of RCA output jacks. Using the provided RCA stereo
cables, connect the LEFT side RCA cables CD player to the LN1 input.

2. Connect the RIGHT side CD player to the LN3 input on the rear of the mixer. Set the LN1/PH-1-LN2
switch on the face of the mixer to LN1. Set the LN3/PH-2-LN4 switch on the face of the mixer to LN3.

MIXER TO RECEIVER OR AMP:

1. The MASTER output jacks are used to connect the mixer to your main amplifier or stereo receiver
LINE or AUX inputs using stereo RCA cables (included).

BACK OF MIXER

IDEAL SETUP

SETUP DIAGRAMS: