UPS with AVR
UPS with automatic
output voltage regulation
UPS with AVR
Disclaimer
We spared no efforts to make sure that the information in this manual is correct and
complete. However no liability is accepted for any errors or omissions. Gembird
Electronics reserves the right to change the specifications of the hardware and
software described in this manual without prior notice.
No part of this manual may be reproduced, transmitted or translated in any language
in any form, by any means, without the prior written permission of Gembird
Electronics Ltd.
Gembird Electronics makes no warranties for damages resulting from corrupted or
lost data due to a mistaken operation or malfunction of the product, the software,
personal computers or peripheral devices.
Gembird® is a registered trademark of GMB Tech (Holland) bv.
Other names or products not mentioned above may be registered trademarks or
trademarks of their respective owners.
Copyright © 2008 Gembird Electronics Ltd. All rights reserved.
UPS with AVR
UPS User manual
Introduction
Thank you for buying the Gembird® UPS with automatic output voltage regulation!
This manual will help you install and use it properly.
UPS with AVR
Features
Automatic output voltage regulation (AVR)
USB controlling interface (for advanced models)
LED status indication
Short circuit protection
Surge, spike and lightning protection
Audible and visual alarms
Overcharge and over discharge protection
Fax/Modem/Telephone or other protection socket (for advanced models)
Package contents
UPS
Power cord
Spare fuse
USB cable and software CD (for advanced models)
UPS with AVR
Specifications
UPS with AVR
Remarks about Safety
In order to keep safe in using the UPS, please comply with the following:
Please charge the battery at least 12 hours before the UPS is in operation.
After the battery is discharged or over three months without operation, the
battery should be charged immediately for at least 12 hours, ensuring the
battery is full and avoiding any unnecessary damage of the battery.
The UPS is specially designed for computer only and it should not be connected
with any inductive or capacitive load, or the pure resistance full load, like
electromotor, daylight lamp, laser printer, etc.
It is normal that the temperature of the UPS surface reaches up to 50 when it is
in operation.
When AC fails and the ON button on the front panel is pressed, the UPS will
output voltage; if the OFF button on the front panel is pressed, the UPS will not
output voltage.
It is forbidden to open the case, because there is danger with electricity. If there
is problem, please handle with the instruction of experts.
It is forbidden to put container containing liquid inside on the UPS, because it will
Loading...