GE Lighting R30 CLFE Users manual

Kick off device out of group

Kick off device out of scene

Kick off device by gateway

BR30 User Manual

Voltage

Function

Initial brightness

Brightness range

CCT range

Initial CCT

Pair

Model

Phenomenon

Factory Default None

Pair Successfully Flash 3 times

Modify Device Name None

Choose light to group None

加组完成 Flash 3 times

Modify Group Name 无

6BC-BR800SS-A1Z

120V

Tunable white

100%

5%~100%

2400-5000K

5000K

Flash 3 times

Choose light to scene Flash 3 times

Add to scene successfully None

Modify Scene None

OTA Flash 3 times

Off-network

Reset Flash 3 times

Memory Function

Memory Function Duration

FTS

Smart Control (Scheduling)

Smart Control Duration

Network Architecture

Group quantity

None

Flash 3 times

Function

Yes

5s

Yes

Yes

1/3/5/15/30s

1/3/5/15min

BLE Mesh

8

Scene quantity

OTA

Gateway Type

Certification

16

Yes

GE HUB

UL+FCC

Remark

Warnng part

1. Factory new: bulb with certain mesh name and password, concrete
content depend on customer.

2. Log in at first time: user use the default mesh name and password to
log in and modify the mesh name and password by self, light will flash 3
times after modifying successfully. The device which use same mesh
name and password should under same network.

3. Reset device: if user forget the mesh name and password they set, they
could rest the device through on/off 5 times the device. Concrete
operations as follow: power on and off the device 5 times, former 3 times
interval time less than 3s, last 2 times on/off operation interval time
between from 3 to 30s. After above operation light will flash 3 times
which means match successfully.

4. Control function: the light has function of on/off, lumen control and
group control.

For additional help, regulatory and safety Information, please go to:
Federal Communications Commission (FCC) Interference Statement
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
Note: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
RF exposure warning
This equipment must be installed and operated in accordance with
provided instructions and the antenna(s) used for this transmitter must