GE Lighting Albeo Installation Manual

GE

Lighting

AlbeoTM LED Luminaire

Linear Lighting
(ALC5 Series)

Features

• 5 year warranty

• Damp location rated

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Installation Guide

WARNING/AVERTISSEMENT

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation or removal.

• Properly ground electrical enclosure.

RISK OF FIRE

• Follow all NEC and local codes.

• Use only UL or IEC approved wire for input/output connections.
Minimum size 18 AWG.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (A)/NMB-3(A)

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.

RISQUES DE DÉCHARGES ÉLECTRIQUES

• Coupez l’alimentation avant d’inspecter, installer ou déplacer le luminaire.

• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.

RISQUES D’INCENDIE

• Respectez tous les codes NEC et codes locaux.

• N’utilisez que des ls approuvés par UL ou IEC pour les entrées/sorties de

connexion. Taille minimum 18 AWG.

Save These Instructions

Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.

Prepare Electrical Wiring

Electrical Requirements

• The LED driver must be supplied with 120-480 VAC, 50/60 Hz per product label and connected to an individual
properly grounded branch circuit, protected by a 15 or 20 ampere circuit breaker.

Grounding Instructions

• The grounding and bonding of the overall system shall be done in accordance with National Electric Code
(NEC) Article 600 and local codes.

imagination at work

Unit Installation

Carefully unpack unit and properly inspect for defects before

1

installing. Wear work gloves to prevent dirt and oil from being
transferred to the luminaire.

Choose a mounting method: chain, cable, rod, or surface mount.

2

NOTE: Please follow all UL, NEC and minimum load rating
guidelines when selecting and installing a cable, chain, or rod.

3

The mounting brackets come pre-installed. Loosen the screws
to move the brackets to a desired location, then re-tighten.
Each mounting bracket can connect to a chain, cable, rod, or
be surface mounted.

Chain or Cable Mounting

Attach to

Attach to
structural

structural
member

member

ALC5 Fixture Weight

Size 120-277V 347/480V

4 ft. xture 8.5 lbs. 11.5 lbs.

8 ft. xture 17 lbs. 20 lbs.

Mounting
brackets

Attach to

Attach to
structural

structural
member

member

Hang two chains/cables from a structural member of the ceiling. Fixture must be supported independently of an outlet
box. Loop chain/cable through the two mounting brackets.

Rod Mounting

Fasten

with nuts

Secure two 1/2” threaded rods into structural members in ceiling. Place a nut on each threaded rod where xture should
hang. Slide mounting brackets onto threaded rods and tighten second nut onto rods to secure xture.

Attach to
structural
member