GE Lighting A19 SW III User Manual

GE Connected A19 CLEDA199S2, input 120Vac, frequency was 60Hz, high
efficiency, safety & stability output. Use Bluetooth 4.1 chip technology to realize the
far distance control. Through the APP to control the PWM signal to dim and even
control the switch on & off of the bulb.
Product features:

1. Controlled by Bluetooth 4.1 to realize the far distance control.

2. CCT range is 2000K-7000K, default CCT is 2700K.

3.With advanced chips to make sure the bulb with high efficiency, low consumption
and stability.

4. Internal constant current output to make sure the high power conversion efficiency
and stability output.

Product Name LED LAMP

Brand Name GE

CLEDA199L2@,LED9D2A19/CL@

Model No.

@ rates for package information,
maybe 1P~10P

Working Voltage 120Vac

Bluetooth Specification Version 4.1

Frequency Range 2400- 2483.5MHz

Channel Number 40

Channel Separation 2MHz

Type of Modulation GFSK

Data Rate 1Mbps(GFSK)

Antenna Type PCB Antenna

Peak Antenna Gain 0.85 dBi

For additional help, regulatory and safety Information, please go to:
Federal Communications Commission (FCC) Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
The grantee is not responsible for any changes or modifications not expressly
approved by the party responsible for compliance. Such modifications could void the
user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance of 20 cm between the radiator and your body.
CAUTION:

- DO NOT USE WITH STANDARD DIMMERS, SEE
INSTRUCTIONS

-NOT FOR USE IN TOTALLY ENCLOSED LUMINAIRES

-SUITABLE FOR DAMP LOCATIONS

-THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY
EXITS
Only use the control provided with or specified by these instructions to control this
lamp. This lamp will not operate properly when connected to a standard
(incandescent) dimmer or dimming control.