Installation instructions
Bevel gears
Series 444F6../446F6../456F6..
Installation and rotation direction
Front-mounted rolling shutter
L
Switching of the rotation direction
For gears pre-set for right tting, turn tube
drive to the right …
R
Built-in rolling shutter
R
L
… until the latching elements of the overrun
clutch are released and the switch mechanism is free (before the overrun clutch locks in
again!)
Turn switch mechanism to the left until it
stops …
… and turn tube drive to the left until the
latching elements of the overrun clutch
snap into place.
Gerhard Geiger GmbH & Co. KG | 100W0331 EN 1118
Installation instructions
Quick assembly system
1. Fitting of the bracket
1 2 3
Since the trunnion of the bracket is
too high …
… it must be shortened to the dimension of 8,5 mm. Please use therefore
the GEIGER assembly aid 444F500.
When the trunnion has been reduced
to the specied dimension, you can
proceed with the gear installation.
2. Installation of the bevel gear with the quick assembly system
4 5 6
Place the bevel gear with the quick
assembly system and the clamping
plate on the trunnion.
7
Align roughly the gear with the drive
rod (45° or 90°)
Tighten the screw on the clamping
plate (screwable from both sides)
with a 3 mm Allen key.
Tightening torque: 3-4 Nm.
The nal alignment with the drive rod
is made on site without removing the
clamping screw.
Gerhard Geiger GmbH & Co. KG | 100W0331 EN 1118
For technical questions, please call our service team at: +49 (0) 7142 938-333.
They will be happy to assist you.
Gerhard Geiger GmbH & Co. KG
Schleifmühle 6 | D-74321 Bietigheim-Bissingen
T +49 (0) 7142 9380 | F +49 (0) 7142 938 230
info@geiger.de | www.geiger.de
Loading...