Page 1
Optional
V
Accessories
CAT-5 Cables
VGA Cables
Related Products
Component Video
Extender
Composite Video
Extender
GA extender SRN
Extends any VGA Monitor up to 150 feet using a Single CAT-5 Cable
The VGA Extender SRN allows users to extend video signals far beyond the A/V rack. The VGA
Extender SRN can be used to extend an analog VGA signal to cover distances up to 150 feet.
Industry standard Category 5e (CAT-5e) cable is used for the extension.
How It Works
The VGA extender SRN sender unit connects to your computer using the supplied VGA cable. The
SRN receiver connects to your monitor - up to 150 feet away. One CAT-5 cable connects the
sender and the receiver to each other, extending your video. The video transmitter and receiver
boxes are small and unobtrusive, allowing installation in small spaces.
Features:
z Extends any VGA or high definition component display up to 150 feet (45 meters)
z One CAT-5e cable for extension
z Supports resolutions up to 1080p, 2K, and 1920 x 1200
Specifications:
z Video Amplifier Bandwidth: 350 MHz
z Input Video Signal: 1.2 volts p-p
z Input Sync Signal: 5 volts p-p (TTL)
z Horizontal Frequency Range: 15-70 KHz
z Vertical Frequency Range: 30 - 170 Hz
z Video In: HD-15 male
z Video out: HD-15 female
z Link Connector: RJ-45 Shielded
z Power Supply: 5V DC
z Power Consumption: 5 watts (max.)
z Dimensions: 1" W x 1" H x 4" D each module
z Shipping Weight: 3 lbs.
Package Includes:
z VGA Extender SRN Sender Unit
z VGA Extender SRN Receive Unit
z 6 foot VGA cable (M-F)
z One 5V external power supply
z User's Manual
1:8 VGA CAT5
Distribution S
EXT-VGA-141SRN
Dystrybucja i sprzedaż: Meditronik Sp. z o.o.
02-952 Warszawa, ul. Wiertnicza 129, tel. (+48 22) 651-72-42, fax (+48 22) 651-72-46
http://www.meditronik.com.pl e-mail: office@meditronik.com.pl
Page 2
VGA Extension
SRN
EXT-VGA-141SRN
User Manual
www.gefen.com
Page 3
ASKING FOR ASSISTANCE
Technical Support:
Telephone (818) 772-9100
(800) 545-6900
Fax (818) 772-9120
Technical Support Hours:
8:00 AM to 5:00 PM Monday thru Friday.
Write To:
Gefen Inc.
c/o Customer Service
20600 Nordhoff St
Chatsworth, CA 91311
www.gefen.com
support@gefen.com
Notice
Gefen Inc. reserves the right to make changes in the hard ware, packaging and
any accompanying doc u men ta tion without prior written notice.
VGA Extender SRN is a trademark of Gefen Inc.
© 2008 Gefen Inc., All Rights Reserved
All trademarks are the property of their respective companies
Page 4
CONTENTS
1 Introduction
2 Operation Notes
3 Features
4 Sender/Receiver Panel Layout
5 Connecting And Operating The VGA Extender SRN
6 Network Cable Wiring Diagram
7 Specifi cations
8 Warranty
Page 5
INTRODUCTION
Congratulations on your purchase of the VGA Extender SRN. Your complete
satisfaction is very important to us.
Gefen
Gefen delivers innovative, progressive computer and electronics add-on solutions
that harness integration, extension, distribution and conversion technologies.
Gefen’s reliable, plug-and-play products supplement cross-platform computer
systems, professional audio/video environments and HDTV systems of all sizes
with hard-working solutions that are easy to implement and simple to operate.
The Gefen VGA Extender SRN
The VGA Extender SRN allows users to extend video signals far beyond the A/V
rack. The VGA Extender SRN can be used to extend an analog VGA signal to
cover distances up to 150 feet. Industry standard Category 5e (CAT-5e) cable is
used for the extension.
How It Works
The VGA extender SRN sender unit connects to your computer using the
supplied VGA cable. The SRN receiver connects to your monitor - up to 150
feet away. One CAT-5 cable connects the sender and the receiver to each other,
extending your video. The video transmitter and receiver boxes are small and
unobtrusive, allowing installation in small spaces.
1
Page 6
OPERATION NOTES
READ THESE NOTES BEFORE INSTALLING OR
OPERATING THE VGA EXTENDER SRN
Display information (EDID) is not sent back to the source. Standard VESA •
resolutions should be output by most computers without the need of an EDID.
If using a non-VESA standard resolution or if EDID is needed, an EDID storage
and relay device is necessary . Gefen recommends the use of a DVI Detective
(part# EXT-DVI-EDID, EXT-DVI-EDIDN, or EXT-DVI-EDIDP) with two VGA to
DVI adapters.
Use industry standard Category-5 (CA T -5) cable to operate the VGA Extender •
SRN system. CAT-5e cable is preferred.
Please connect all the cables between the computer and the VGA Extender •
SRN before powering up the VGA Extender SRN unit.
The VGA Extender SRN units are housed in a metal box for better RF •
shielding.
2
Page 7
FEATURES
Features
Extends any VGA or high defi nition component display up to 150 feet (45 •
meters)
One CAT-5e cable for extension•
Supports resolutions up to 1080p, 2K, and 1920 x 1200•
Package Includes
(1) VGA Extender SRN Sender Unit
(1) VGA Extender SRN Receiver Unit
(1) 6 Foot VGA cable (M-F)
(1) 5V DC Power Supply
(1) User’s Manual
3
Page 8
SENDER/RECEIVER PANEL LAYOUT
Sender Unit
5V DC
Power Input
VGA Out
Receiver Unit
Link Light
Power Light
VGA In
Focus
Trim Pot
The link light will stay on when a VGA connection is made with the source and the
sender unit. If the link light turns off verify that the VGA cable is connected properly
from the source to the sender unit and the display to the receiver unit. The receiver
end link light will stay on as long as a CAT-5e cable is connected between the sender and receiver unit
The power light will stay on as long as the power supply is connected to the sender
unit.
Link Light
Brightness
Trim Pot
Power Light
4
Page 9
CONNECTING AND OPERATING THE VGA EXTENDER SRN
How to Connect the VGA Extender SRN
Connect the VGA Extender SR sender unit to the VGA output on the back of 1.
your computer. The supplied six foot M-F VGA cable connects the CPU and
sender unit together.
Connect the VGA Extender SR receiver unit to your monitor with the VGA 2.
cable that is attached to your monitor.
Connect the CAT5 cable between the VGA Extender SR sender and receiv-3.
er’s CAT5 input.
Plug the 5 volt power supply into the sender unit. The VGA Extender SR 4.
receiver will draw power from the sender.
NOTE: Display information (EDID) is not sent back to the source. Standard VESA
resolutions should be output by most computers without the need of an EDID.
If using a non-VESA standard resolution or if EDID is needed, an EDID storage
and relay device is necessary. Gefen recommends the use of a DVI Detective
(part# EXT-DVI-EDID, EXT-DVI-EDIDN, or EXT-DVI-EDIDP) with two VGA to DVI
adapters.
BRIGHTNESS AND FOCUS TRIM POTS
The brightness and focus adjustments are found on the receiver unit and will help
compensate for issues that can be introduced by outside interference and cable
variances. If the outgoing image is too dark or too bright, the brightness trim pot
can be tuned to help brighten the image. If there is a ghosting or blurring effect
on the image, the focus trim pot can be used to eliminate these artifacts. Insert a
small fl at head device, such as a screw driver into either the brightness or focus
trim pot hole. Turn the trim pot in millimeter increments in either a clockwise or
counterclockwise direction. Once the desired brightness and focus are reached,
simply remove the adjustment device from the trim pot hole.
5
Page 10
NETWORK CABLE WIRING DIAGRAM
Gefen has specifi cally engineered their products to work with the TIA/EIA-568-B
specifi cation. Please adhere to the table below when fi eld terminating cable for
use with Gefen products. Failure to do so may produce unexpected results and
reduced performance.
Pin Color
1 Orange / White
2 Orange
3 Green / White
4 Blue
5 Blue / White
6 Green
7 Brown / White
8 Brown
CAT-5, CAT-5e, and CAT-6 cabling comes in stranded and solid core types.
Gefen recommends using solid core cabling. CAT-6 cable is also recommended
for best results.
Each cable run must be one continuous run from one end to the other. No splices
or use of punch down blocks.
12345678
6
Page 11
SPECIFICATIONS
Video Amplifi er Bandwidth ....................................................................... 350 MHz
Input Video Signal .............................................................................. 1.2 Volts p-p
Input Sync Signal ........................................................................ 5 Volts p-p (TTL)
Horizontal Frequency Range ................................................................ 15-70 KHz
Vertical Frequency Range ................................................................... 30 - 170 Hz
Video In ............................................................................................... HD-15 male
Video out .......................................................................................... HD-15 female
Link Connector .............................................................................. RJ-45 Shielded
Power Supply .............................................................................................. 5V DC
Power Consumption ........................................................................ 5 Watts (max.)
Dimensions .......................................................... 1” W x 1” H x 4” D each module
Shipping Weight ............................................................................................ 3 lbs.
7
Loading...