Gefen EXT-UHDV-WP-HBTLS-TX Datasheet

EXT-UHDV-WP-HBTLS-TX

4K Ultra HD Multi-Format 2x1 HDBaseT™ Wall-Plate Sender
with Scaler, Auto-Switching, and POH

AUTO-SWITCH 4K ULTRA HD
HDMI AND VGA, SCALE, AND
EXTEND UP TO 70 M / 230 FT,
OVER A SINGLE CAT-5

The Gefen EXT-UHDV-WP-HBTLS-TX is a high­performance solution in standard US electrical
wall-plate form factor for switching 4K Ultra
HD HDMI and VGA inputs, and extending them
up to 70 meters (230 feet) at 1080p and 40
meters (130 feet) at 4K, over a single CAT­5e cable. Switching between the HDMI and
VGA can be set to Automatic or be done
manually via the front panel button or RS-232.
It supports 10.2 Gbps of data throughput and
300 MHz TMDS Clock frequency, accepting
HDMI 2.0 signals up to 4K 60 Hz 4:2:0 or
4K 30 Hz 4:4:4. This extender uses Gefen’s
implementation of the HDBaseT™ technology
with enhancements such as Advanced EDID
Management. The HDMI input accommodates
resolutions up to 4K Cinema-DCI (4096 x 2160
to 30 Hz 4:4:4) and 4K Ultra HD (3860 x 2160
to 60 Hz, 4:2:0, or 30 Hz 4:4:4), with HDCP

1.4. Highest performance multichannel digital
audio including 7.1 channels of LPCM and HBR
(High Bit Rate) digital audio formats, such as
Dolby Atmos®, Dolby® TrueHD, DTS:X™, and
DTS-HD Master Audio™ are passed through
to the HDMI output. The VGA input features a
companion L/R analog audio input, and accepts
VESA and CEA resolutions up to WUXGA (1920
x 1200 to 60 Hz, 4:4:4) and 1080p Full HD
(1920 x 1080 at 60 Hz, 4:4:4). A powerful built­in scaler can upscale lower resolution VGA
signals with legacy aspect ratio to widescreen
WUXGA, ensuring stunning presentations and
smooth switching transitions between the HDMI
and the VGA sources. The EXT-UHDV-WP­HBTLS-TX extends RS-232 when used with
a compatible Receiver unit such as the Gefen
EXT-UHDA-HBTL-RX, facilitating the control
of A/V sources placed near the Sender from
the viewing location, and sending automation
commands to the display or another device
placed near the Receiver unit. It also accepts
RS-232 commands for switching, scaler
controls, and EDID management from a third­party controller placed near the Sender or
remotely by the Receiver. HDBaseT™ standard
POH (Power Over HDBaseT™) technology

powers the Sender remotely from the Receiver
unit, using the same cable that extends the
HDMI signal. This feature simplifies installation
in many cases where supplying power directly
to the wall-plate is not practical. Alternatively,
if powering the wall-plate Sender from the
Receiver unit is not feasible, a separately
available power supply can be hard-wired to a
detachable “captive-screw” Phoenix connector
on the back of the wall-plate. The Sender
uses the North American standard 2-gang
wall-plate form factor and can work with most
“open-back” low-voltage installation brackets
and table boxes. It is compatible with most
standard North American Decora® wall-plates
(a white-colored wall-plate is included). It also
accommodates Gefen locking HDMI cables for
secure and reliable connections.

Note:

Shielded (STP) CAT-5e or better cable is
recommended. Unshielded (UTP) CAT-5e or
better cable may be acceptable depending on
cable quality but is not the preferred choice.
Care should always be given to keep these
cables away from power lines and other sources
of electromagnetic interference.

FEATURES

*

§ Supports 300 M Hz TMDS Clock and data throughput of up to

10.2 Gbps

§ Automatic switching of 4K HDMI and VGA

§ Manual switching of 4K HDMI and VGA via front panel but ton

or RS-232

§ VGA scaling up to 1920 x 1200 with picture adjustments

§ Extend HDMI, VGA with analog audio, and RS-232 over a

single CAT-5e:

§ 4K Ultra HD (384 0 x 2160 @ 60 Hz, 4:2:0), up to 130

feet/40 meters (8-bit color)

§ 4K Ultra HD (384 0 x 2160 @ 30 Hz, 4:4:4), up to 130

feet/40 meters (8-bit color)

§ 4K Cinema (DCI) (4 096 x 2160 @ 24 or 30 Hz 4:4:4), up to

130 feet/40 meters (8-bit color )

§ 1080p Full HD (60 Hz) or W UXGA (1920x1200 @ 6 0 Hz), up

to 230 feet/70 meters (up to 12-bit Deep Color)

§ HDMI Features Supported:

§ HDMI 2.0

§ HD CP 1.4

§ 12-bit Deep Color (at 1080p)

§ LPCM 7.1, Dolby Atmos®, Dolby® TrueHD, DTS: X™, and

DTS-HD Master Audio™ pass-through

§ 3DTV pass-through

§ CEC pass-through

§ Lip Sync pass-through

§ Analog L /R audio input for VGA

§ RS-232 control of switching, scaler, and EDID management

functions

§ Bi-Directional RS-232 extension when used with a compatible

Receiver

§ Power over HDBaseT™ (POH) provides power to the Sender

from a compatible Receiver over the link cable

§ Sender can also be locally powered using the 2-pin Phoenix

connector on back panel

§ Uses Gefen’s implementation of HDBaseT™ technology with

enhanced features

§ Advanced EDID Management for rapid integration of source

and display

§ Field-updateable firmware via mini- USB port, using the Gefen

Syner-G™ software

§ North American standard 2-gang wall-plate form factor

§ Works with most standard Nor th American 2-gang Decora®

wall-plates (white wall-plate is included)

§ Works with most Nor th American 2-gang t able boxes and

“open-back” low-voltage installation brackets

SPECIFICATIONS

*

§ Recommended Receiver: EXT-UHDA-HBTL-RX

§ Maximum T MDS Clock: 300 M Hz

§ Total Signal Bandwidth/Data Rate: 10.2 Gbps

§ Video Input Connector:

(1) HDMI Type A 19-pin, female, locking
(1) VGA HD -15, female

§ L/R Analog Audio Input port:

(1) 3.5mm mini-stereo jack

§ Link Connector: (1) RJ-45, shielded

§ RS-232 port: (1) 4-pin Phoenix

§ DC In por t: (1) 2-pin Phoenix

§ Firmware Update por t: (1) USB-Mini-B, female

§ Power Indicator LED: (1) Blue

§ Link Indicator LED: (1) Green

§ HDCP Indicator LED: (1) Green

§ HDMI Input Indicator LED: (1) Green

§ VGA Input Indicator LED: (1) Green

§ Auto-Manual Switch: (1) tact-t ype

§ Power Requirement: Powered through POH from a compatible

Receiver (recommended), or via the Phoenix connector on
back panel, using a hard-wired 12V 1~2A DC power supply

§ Recommended Power Supply (sold separately):

EXT-PS121.5AIP-3P-6 (DC plug needs to be removed)

§ Power Consumption: 6W maximum

§ Operating Temperature: +32 to +122 °F (0 to +50 °C)

§ Operating Humidity: 5% to 90% R H, non-condensing

§ Storage Temperature: -4 to +185 °F (-20 to +85 °C)

§ Storage Humidity: 0% to 95% RH, non-condensing

§ MTBF: 50000 hours

§ Overall Dimensions ( W x H x D, not including the connectors):

3.5” x 4.2” x 1.74” (89mm x 104.5mm x 44mm)

§ Mounting Cavity Dimensions ( W x H x D, behind the mounting

plate): 3.6” x 2.8” x 2” (92mm x 72mm x 50mm)

§ Net Weight: 0.6 lbs (0.27 kg)

§ Shipping Weight: TBD

RS-232 Automation

Control Device

or

Device-To-Be-Controlled

Powered Speakers

or Audio Amplifier

w/analog L/R input

Display

EXT-UHDA-HBTL-RX
Receiver (Back)

Audio Amplifier

w/ optical digital input

Audio Amplifier

w/ coaxial digital input

Link

Power

Input

Auto

EXT-UHDV-WP-HBTLS-TX

Firmware

EXT-UHDV-WP-HBTLS-TX
Sender (Front)

HDBaseT™

(POH)

Out

EXT-UHDV-WP-HBTLS-TX
Sender (Back)

HDCP

VGA

Reset

VGA In

Audio In

HDMI

HDMI In

In*

RS-232

* Do NOT connect if using POH

CAT-5e CABLE

HDMI CABLE

VGA CABLE

RS-232 CABLE

3.5MM AUDIO CABLE

OPTICAL DIGITAL AUDIO
COAXIAL DIGITAL AUDIO

VGA Source

4K Ultra HD Source

RS-232 Automation

Control Device

or

Device-To-Be-Controlled

EXT-UHDV-WP-HBTLS-TX

* Featur es and speci ficati ons are subje ct to chang e without n otice.

5919 Sea Otter Place, Suite 100 C arlsbad , CA 92010 - 8 00.472. 5555
All trad emarks an d register ed tradema rks are pr operti es of their re spectiv e owners.
©2018 Nor tek Security & C ontrol. A ll right s reserve d. Gefen® is a regist ered trad emark of No rtek Se curity & C ontrol. E XT-UHDV-W P-HB TLS-T X - Rev B - May 20 18