Gefen EXT-RACK-1U Quick Start Guide
QUICK START GUIDE
*Preferred
1U Rack Tray
EXT-RACK-1U
EXT-RACK-1U-GRY
Congratulations on your purchase of the Gefen 1U Rack Tray. Your complete satisfaction is very important to us.
This product has been designed for rack mounting of specic half-rack wide Gefen products. It helps keep your installation secure
and organized. This tray takes up just 1 Rack Unit (1U) height (1.75”), but can also accommodate lower prole as well as taller
enclosures (as long as there is clearance above the tray). For a list of compatible Gefen products, please see the EXT-RACK-1U
page at www.gefen.com
QUICK START GUIDE
*Preferred
i
*Preferred
Start Here
QUICK START GUIDE
Installation
Remove Rubber Feet
1
Make sure you have everything that came with your product:
(1) 1U Rack Tray (EXT-RACK-1U or EXT-RACK-1U-GRY)
(1) Quick-Start Guide (QSG-EXT-RACK-1U)
Please note the following:
1. Product-to-rack mounting screws are not provided with this rack tray. If these
screws did not come with your Gefen product, you will need to purchase them
separately. Please use 6-32 at head machine screws, approximately 3/16” or
5mm long. The use of longer screws could damage your product. Such damage
will not be covered under warranty.
2. This rack tray is available in two nishes to complement a variety of Gefen
enclosures: Bronza (EXT-RACK-1U) and Metallic Gray (EXT-RACK-1U-GRY).
In case of difculties, or if you have any questions, please get in touch with the
Gefen Technical Support. Refer to the last page of this Quick Start Guide for contact
information.
INFORMATION:
For a list of compatible products, please see the
EXT-RACK-1U web page at www.gefen.com
1. Turn the unit upside down and remove the rubber feet if attached.
Loading...