Page 1
www.gefen.com
®
Component
w/Audio Extender
EXT-COMPAUD-141
USER MANUAL
Page 2
Technical Support:
Telephone (818) 772-9100
(800) 545-6900
Fax (818) 772-9120
Technical Support Hours:
8:00 AM to 5:00 PM Monday thru Friday PST
Write To:
Gefen Inc.
C/O Customer Service
20600 Nordhoff St
Chatsworth, CA 91311
www.gefen.com
support@gefen.com
Notice
Gefen Inc. reserves the right to make changes in the hard ware, packaging and any
accompanying doc u men ta tion without prior written notice.
Component w/ Audio Extender is a trademark of Gefen Inc.
© 2009 Gefen Inc., All Rights Reserved
ASKING FOR ASSISTANCE
All trademarks are the property of their respective companies.
Rev X2
Page 3
TABLE OF CONTENTS
INTRODUCTION / HOW IT WORKS / OPERATION NOTES
FEATURES
PANEL DESCRIPTION
PANEL DESCRIPTION
INSTALLATION INSTRUCTIONS / BRIGHTNESS AND FOCUS TRIM POTS
CAT5 WIRING DIAGRAM
CONNECTIONS DIAGRAM
SPECIFICATIONS
WARRANTY
1
2
3
4
5
6
7
8
9
Page 4
Thank you for purchasing the Component with Audio Extender by Gefen, Inc.
Extend your audio and video signal using the Gefen Component Audio Extender . Place
your source anywhere and extend the signal up to 1000 feet (300 meters) away. The
Component Audio Extender will extend Analog Component as well as Analog Audio
and Digital Audio via SPDIF or TOSlink.
INTRODUCTION
1
READ THESE NOTES BEFORE INSTALLING
OR OPERATING THE COMPONENT EXTENDER SYSTEM
• Use industry standard Category-5e (CAT-5e) cable to operate the Component with
Audio Extender system. CAT-5e cable is preferred.
• Please connect all the cables between the source and the Component with Audio
Extender before powering up the Component with Audio Extender unit.
• The Component with Audio Extender units are housed in a metal box for better RF
shielding.
OPERATION NOTES
HOW IT WORKS
The Component Audio Extender sender unit connects to any component video and
audio source using the supplied Component and RCA cables. The receiver unit connects to your HDTV component video display and audio input up to 1000 feet (300
meters) away . One CAT-5e cable is used to connect the sender to receiver for perfect
video extension up to 1080p. The sender and receiver will be powered individually by
5V power supplies.
Page 5
Features
• Supports up to 1080p component video
• Supports analog L+R audio
• Plug and play installation
• Equalizations for different CAT-5 skews
• One CAT-5 cable for extension
Includes:
(1) Component Audio Extender Sender
(1) Component Audio Extender Receiver
(1) 6ft. 5 RCA Component w/Audio Cable
(2) 5V Power Supply
FEATURES
2
Page 6
PANEL DESCRIPTIONS
3
Sender
5V Power
Supply Input
Component
Input
Analog Audio
Input
SPDIF Input
Optical /
Toslink Input
Power Light
Indicator
5V Power
Supply Input
Component
Output
Analog Audio
Output
SPDIF Output
Optical /
Toslink Output
Power Light
Indicator
Receiver
Page 7
PANEL DESCRIPTIONS
4
CAT-5e
Cable Input
Brightness
Trim Pot
Focus
Trim Pot
Sender
Receiver
CAT-5e
Cable Input
Page 8
Connect the Component output of your source / receiver to the input on the
Component Extender Sender Unit.
Connect the audio output of your source / receiver to the input on the
Component Extender Sender Unit.
Connect the Component input of your display to the Component output on the
Component Extender Receiver Unit.
Connect the audio input of your display to the Component output on the
Component Extender Receiver Unit.
Connect a CAT-5 cable between the Component Extender sender and
receiver’s CAT-5 input.
Power on the display fi rst and then the source.
INSTALLATION INSTRUCTIONS
1.
2.
3.
4.
5.
6.
5
Note: Any of the 3 RCA lines can be used for any color. Both ends will need to be
matched for the signal to be passed through correctly.
BRIGHTNESS AND FOCUS TRIM POTS
The brightness and focus adjustments are found on the receiver unit and will help
compensate for issues that can be introduced by outside interference and cable
variances. If the outgoing image is too dark or too bright, the brightness trim pot can
be tuned to help brighten the image. If there is a ghosting or blurring effect on the
image, the focus trim pot can be used to eliminate these artifacts. Insert a small fl at
head device, such as a screw driver into either the brightness or focus trim pot hole.
Turn the trim pot in millimeter increments in either a clockwise or counterclockwise
direction. Once the desired brightness and focus are reached, simply remove the
adjustment device from the trim pot hole.
Page 9
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
RJ-45 Jack
RJ-45 Jack
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
1
8
1
8
CAT5 WIRING DIAGRAM
6
Page 10
7
CONNECTIONS DIAGRAM
Page 11
Video Amplifi er Bandwidth..............................................................................350 MHz
Input Video Signal.....................................................................................1.2 Volts p-p
Input Sync Signal...............................................................................5 Volts p-p (TTL)
Horizontal Frequency Range.......................................................................15-70 KHz
Vertical Frequency Range............................................................................30-170 Hz
Video In/Out....................................................................................3 RCA Component
Audio In/Out.........................................................2 RCA Audio, 1 S/PDIF, 1 TOSLINK
Link Connector.....................................................................................RJ-45 Shielded
Power Supply......................................................................................................5V DC
Power Consumption.............................................................................10 watts (max.)
Dimensions.................................................................................5.2”W x 1.2”H x 2.7”D
Shipping Weight...................................................................................................3 lbs.
SPECIFICATIONS
8
Page 12
9
WARRANTY
Gef
en warrants the equipment it manufactures to be free from defects in material
and workmanship.
I
f
equipment fails because of such defects and Gefen is notifi ed within two (2)
y
ears from the date of shipment, Gefen will, at its option, repair or replace the
e
quipment, provided that the equipment has not been subjected to mechanical,
e
lectrical, or other abuse or modifi cations. Equipment that fails under conditions
other than those covered will be repaired at the current price of parts and labor in
eff
ect at the time of repair. Such repairs are warranted for ninety (90) days from
the day of reshipment to the Buyer.
This warranty is in lieu of all other warranties expressed or implied, including
without limitation, any implied warranty or merchantability or fi tness for any
articular purpose, all of which are expressly disclaimed.
1. Proof of sale may be required in order to claim warranty.
2.
ustomers outside the US are responsible for shipping charges to and from
efen.
.
opper cables are limited to a 30 day warranty and cables must be in their
original condition.
The information in this manual has been carefully checked and is believed to
be accurate. However, Gefen assumes no responsibility for any inaccuracies
that may be contained in this manual. In no event will Gefen be liable for
direct, indirect, special, incidental, or consequential damages resulting from
any defect or omission in this manual, even if advised of the possibility of such
damages. The technical information contained herein regarding the features and
pecifi cations is subject to change without notice.
For the latest warranty coverage information, please visit Gefen’s Warranty web
age at http://www.gefen.com/kvm/aboutus/warranty.js
p
RODUCT REGISTRATIO
N
lease register your product online by visiting Gefen’s web site at
http://www.gefen.com/kvm/Registry/Registration.jsp
Page 13
Rev X2
20600 Nordhoff St., Chatsworth CA 91311
1-800-545-6900 818-772-9100 fax: 818-772-9120
www.gefen.com support@gefen.com
Pb
Loading...