INSTALLATION INSTRUCTIONS / HOW TO ADJUST THE PICTURE
CAT5 WIRING DIAGRAM
SPECIFICATIONS
WARRANTY
Page 4
INTRODUCTION
Thank you for purchasing the Component with Audio Extender by Gefen, Inc.
Extend your audio and video signal using the Gefen Component Audio Extender. Place
your source anywhere and extend the signal up to 1000 feet (300 meters) away. The
Component Audio Extender will extend Analog Component as well as Analog Audio and
Digital Audio via SPDIF or TOSlink.
HOW IT WORKS
The Component Audio Extender sender unit connects to any component video and audio
source using the supplied Component and RCA cables. The receiver unit connects to your
HDTV component video display and audio input up to 1000 feet (300 meters) away. One
CAT-5e cable is used to connect the sender to receiver for perfect video extension up to
1080p. The sender and receiver will be powered individually by 5V power supplies.
OPERATION NOTES
READ THESE NOTES BEFORE INSTALLING
OR OPERATING THE COMPONENT EXTENDER SYSTEM
• Use industry standard Category-5e (CAT-5e) cable to operate the Component with
Audio Extender system. CAT-5e cable is preferred.
• Please connect all the cables between the source and the Component with Audio
Extender before powering up the Component with Audio Extender unit.
• The Component with Audio Extender units are housed in a metal box for better RF
shielding.
Connect the Component output of your source / receiver to the input on the
1.
Component Extender Sender Unit.
Connect the audio output of your source / receiver to the input on the Component
2.
Extender Sender Unit.
Connect the Component input of your display to the Component output on the
3.
Component Extender Receiver Unit.
Connect the audio input of your display to the Component output on the
4.
Component Extender Receiver Unit.
Connect a CAT-5 cable between the Component Extender sender and receiver’s
5.
CAT-5 input.
Power on the display rst and then the source.
6.
Note: Any of the 3 RCA lines can be used for any color. Both ends will need to be
matched for the signal to be passed through correctly.
BRIGHTNESS AND FOCUS TRIM PODS
If your picture is too dark or if you see a “ghosting” effect on your display, then the trim
pods will help correct this problem. If your picture is too dark then the brightness trim
pod will help brighten up your display. If your picture has a “ghosting” effect and/or
noise, then the focus trim pod will help sharpen up your picture. Turn trim pods to the
left and right to eliminate any noise on your picture.
5
Page 9
CAT5 WIRING DIAGRAM
8
1
1
2
RJ-45 Jack
Orange
White/Orange
White/Green
3
4
Blue
5
6
7
Green
White/Blue
White/Brown
8
Brown
1
2
RJ-45 Jack
3
4
5
6
6
7
8
8
1
Page 10
SPECIFICATIONS
Video Amplier Bandwidth....................................................................................350 MHz
Actual Bandwidth...................................................................................................120MHz
Input Video Signal...........................................................................................1.2 Volts p-p