Geetek Electronics 2006GE2002T 2 User Manual

Operational Manual of Ceiling Fan Remote

(Manual of Remote Control Ceiling Fan)

1. Warning:

(1) Before you connect the power, be sure to turn off the power of the ceiling fan.

2. Cautions:

(1) Before operating, switchover the manual speed of the ceiling fan to the high speed position.
(2) In case that the ceiling fan has the light control device, before operating, turn light to the ON

position.

(3) The remote controller has 4 kinds of outer code, with coding No. 1∼4.
(4) The outer code of remote controller shall be the same as the outer code of the receiver,

otherwise, the inner code is unable to set.

(5) The outer code and inner code of the remote controller must be completely the same as

receiver’s, so that the remote can function well.

(6) Battery box of the remote controller has a SET key, and when pressing down this key, one

inner code will be sent to the receiver. Therefore, you may set the inner code of the receiver
same as the remote controller’s. When the inner code setting is finished, the receiver can test
automatically the function of the ceiling fan.

(7) If the battery of the remote controller is removed away too long and reloaded again, then the

remote controller will send automatically one set of inner code to the receiver, and that
functions completely the same as the SET key.

(8) If the outer code of your ceiling fan is the same as other ’s ceiling fan, be sure to turn off the

power of other’s ceiling fan before putting into the battery of the remote controller or
pressing down the SET key of yours. Wait after the inner code of your ceiling fan is set, then
turn on the power of other’s ceiling fan. If the outer code of other’s ceiling fan is different
from your ceiling fan’s, then it is unnecessary to turn off the power of other’s ceiling fan.

1

N

R

3. WIRING DIAGRAM

AC IN L (BLACK)
AC POWER INPUT

AC IN N (WHITE)

RECEIVER

4. KEY OPERATION

TO MOTOR L (RED)

DIMME

TO MOTOR N (WHITE)
FOR LIGHT (BLUE)

FOR LIGHT (ORANGE)

ON/OFF

OTE: 1. FOR LIGHT (BLUE): DIMMER

2. FOR LIGHT (ORANGE): ON/OFF

(1) FAN STOP KEY

ON STOP

(2) FAN KEY

STOP REMEMBER FAN SPEED（LAST STOP STATUS）

HI MED LOW

2