GE ZXD30P Installation Instruction
Installation
Instructions
PROFESSIONAL STYLE PANEL
ACCESSORYKIT
ZXD30P
BEFORE YOU BEGIN
Read these instructionscompletelg and carefullg.
• IMPORTANT- Save these instructions
for local inspector's use. Observe all governing
codes and ordinances.
• Note to Installer - Be sure to leave these
instructions with the Consumer.
Note to Consumer - Keep these instructions
for future reference.
TOOL AND MATERIALS REQUIRED
• Phillips screwdriver
PARTS SUPPLIED
Stainless Steel Professional Stgle Drawer
Accessorg
This kit contains a stainless steel professional stgle panel
with a handle and a lamp jewel imbedded inthe bottom
right side. Install the warming drawer according to the
installation instructions packed with the product.
NOTE:The ZXD30P professional drawer panel with
handle is a one-piece ossemblg that replaces the
original drawer front and tubular handle. The original
tubular handle (oro custom handle) cannot be
installed onto this professional drawer panel.
This ZXD30P occessorg is designed to fit 30" worming
drawers manufactured after Februarg 2006.
STEP 2 REMOVE ORIGINAL
DRAWER FRONT
• Remove the three screws from the bottom
of the drawer edge.
• Remove the four screws on the inside
of the drawer at the top. Retain all screws.
- Support the drawer front as gou remove screws
to prevent the front panel from falling.
,' /
I I
/
STEP 3 REMOVE THE PACKAGING
• Open the carton and remove the panel.
Remove all protective covering on both sides.
A CAUTION: Keep allplasticmaterial
awog from babiesand smallchildren.Plasticcould
pose a chokingor suffocationhazard.
STEP 4 INSTALL PANEL ONTO DRAWER
JSTEP 1 I PREPARE DRAWER
FOR PANEL INSTALLATION
IMPORTANT: The drawer must be installed into
the cabinet before opening the drawer.
• Open the drawer opproximatelg halfwag.
• Turn the worming drawer to "OFF."
31-i0701-i I
10-08 JR
Printed in the United States
• Install the panel ossemblg to the exposed drawer
front using the original 7 screws.
Loading...