GE ZPBS360, ZPSS360 User Manual

BEFORE YOU BEGIN

Read these instructions completely and carefully.

• Note to Installer – Be sure to leave these

instructions with the Consumer.

• Note to Consumer – Keep these instructions with

your Owner’s Manual for future reference.

Installation
Instructions

ACCESSORY PANEL KITS

ZPSS360 – Stainless Steel
ZPBS360 – Black Acrylic

Kit Contents

• 2 Filler panels
(with ZPSS360 only)

• Door panel

• Grille panel

Tools Required

• Phillips screwdriver

• Safety glasses

• Gloves to protect against
sharp edges

• Wood block

• Hammer

REMOVE HANDLES AND TRIM

• Open the door to 90°. Remove the 6 Phillips head
screws from the door handle.

• Remove handle. Retain all screws.

• Remove 6 screws holding trim. Lift off trim.
Retain screws.

STEP 1

INSTALL PANELS

• Remove protective film from appearance panel.

• Slide panel into the door trim.

• If installing stainless steel panels, first slide filler
panel into the door trim, then slide stainless panel
into the trim.

• If necessary, tap with a wood block until panel slips
under the hinge side trim.

• There are two sets of holes in the handle side trim.
Replace side trim by installing the original screws
in the FRONT screw holes.

• Secure the handle to the door using the REAR
screw holes.

STEP 2

Use Rear Holes

to Secure Handle

Use Front Holes

to Secure Trim

INSTALL GRILLE PANEL

• Remove the protective film from the appearance panel.

• Raise the grille panel to the stop position.

• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.

• Slide the panel over the metal backer panel and into
the trim.

• If installing Stainless steel panels, first slide the filler panel
into the trim, then slide the stainless panel into the trim.

• If necessary, tap with a wood block until the panel slips
under the top trim piece.

• Reassemble bottom trim. Tighten the screws.

• Adjust the hinge spring to accommodate the panel
weight, if necessary.

STEP 3

31-46149
224D1889P009

06-08 JR

Note: Product improvement is a continuing endeavor at General Electric.
Therefore, materials, appearance and specifications are subject to change
without notice.

GE Consumer & Industrial

Appliances
General Electric Company
Louisville, KY 40225
ge.com

Loosen

Side
Trim

Screw

Loosen

Side
Trim

Screw

Adjust Nut Below

Spring to Accommodate

Panel Weight