GE ZICP720ASBSS, ZICP720ASCSS, ZICP720ASDSS, ZICP720AXASS, ZICP720BSBSS Installation Guide

Installation

Instructions

Professional Stgle
Bottom-Freezer Refrigerators

ZICP720

Design Guide

With Installation Instructions

@

Monogram:

Safety Information

BEFOREYOUBEGIN

Readthese instructions completely and carefully.

•INPORTANT-Savetheseinstructionsfor

local inspector's use.Observeall governing codes and
ordinances.

• Note to Installer- Besureto leavetheseinstructions

with the Consumer.

• Note to Consumer- Keeptheseinstructionswith uour

Owner's Manual for future reference.

WARNING:

Thisappliance must be properlUgrounded.See"Grounding
the Refrigerator,"page6.

AVERTISSEMENT'.

Cetappareil doit _tre correctement mis 6 la terre.
Consultez<<Mise6 laterre du rdrig@rateur >>,page 6.

If Uou receiveda damaged refrigerator,Uoushould
immediately contact your dealeror builder.

CAUTION:

Dueto the weight and sizeof this refrigerator,and to reduce
the riskof personalinjurUor damage to the product-THREE

PEOPLEAREREQUIREDFORPROPERINSTALLATION.

PRUDENCE'.

Acausedu poidsetdelatailledece rdrig_ratoretpourr_duire
lerisquedeblessureetdedommages,ILFAUTTROISPERSONNES

POURFAIREL'INSTALLATIONCORRECTEMENT.

SkillLevel- Installation of this refrigerator requires

basic mechanical, carpentru and plumbing skills.Proper
installation isthe responsibilitUof the installer.Product
failure dueto improper installation is not coveredunder
the GEApplianceWarrant U.Seethe Owner's Manual for
warrant Uinformation.

WARNING:

• Theserefrigerators are top-hea% and must besecured
to preventthe possibilitUof tipping forward. Anti-Tip
protection is required.Seepages 9 and !0 for details.

• Usethis appliance only for its intended purpose.
ImmediatelUrepair or replace electricservice cords that
become fraued or damaged.
Unplugthe refrigerator before cleaning or making repairs.
Repairsshould bemade bu a qualified servicetechnician.

AVERTISSEMENT'.

• Cesrdrig@rateurssont Iourdsen haut et ilfaut les
arrimer pour @viterlear basculement. IIfaut avoir un
sgst@mede protection contre lerenversement.Voir
lesd_tails pages 9 et !0.

• IIne faut utiliser cetappareil que pour I'utilisation
appropri@e.

• R@parezou remplacezimm@diatementtout cordon
@lectriqueeffiloch@ou endommag@.

• IIfaut d@brancherlerdrig@rateuravant le nettoyage
ou toute intervention.

• Lesr@parationsdoivent@trefaites parun technicien qualifi&

For Monogram local service in gout area,
call 1.800.444.1845.

For Monogram service inCanada, call 1.888.880.3030.
For Monogram Partsand Accessories,call L800.626.2002.

www. monogram.cam

CONTENTS

Planning Guide

The Installation Space ......................3

Dimensions and Clearances ..........3

!30 ° Door Swing ..................................4

90 ° Door Swing ....................................5

Installation Instructions

Tools, Hardware, Trim,

Materials, Flooring ..............................6

Grounding the Refrigerator ............6

Step !, Remove Packaging ............7

Step 2, Install Water Lines ..............7

Step 3, Install New Side Trim ..........8

Step 4, Install Side Panels ................8

Step 5, Install Anti-Tip Brackets....9

Step 6, Install New Top Trim ........!0

Step 7, Level Refrigerator ..............!0

Step 8, Alternate Anti-Tip

Procedure ..............................!!

Step 9, Secure Refrigerator

to Cabinetrg ........................ii

2

Step !0, Install Center

Trim Strip ............................12

Step !!, Install Grille BaseCover....!2

Step 12, Remove Both Grille

Panels (if present) ..........13

Step 13, Install Grille Panel

Onto Hinges ......................13

Step 14, Adjust Door Swing ..........14

Step 15, Check and Correct

Door Alignment ..............14

Step 16, Connect Water Supplg ..!6

Step 17, Connect Power ................17

Step 18, Start Icemaker ................17

Step 19, Install Toekick ..................17

Design Guide

THE INSTALLATION SPACE

The installation space must be 71-1/2",

f 71-1/2"FinishedWidth ........................................f

ll 2-5'16" ',

"1 Wall

/k 5/'j E!ectricalf 24-3/ 6"-I View

--/ _ 6 , mm_ 6" |

!, 1 t

max I 10 i ]u .

83-I/2"tl ' 75 From

rain J_ 24"Cutout i Finished

FinishedI Depth , Floorto

• I ,, Bottomof

upenmg| _" W " 5" Electrical

I / " t aterSupply ,, WaterSupply T Area

" i I _ j

/ I, i

Z ............26 ...................\ /: ............26" .................\

3-1/2" 3-1/2"

Water And Electrical Locations

Electrical and water supply must be located

as shown.

The cutout depth must be 24"
The refrigerator will project forward, slightly

beyond adjacent cabinetry, depending on your
installation.

Cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot

exceed the 24" installation depth shown. The top
case trim overlaps the bottom of the soffit.

DIMENSIONS AND CLEARANCES

71-1/2" 25-3/4"

CaseWidth CaseDepth

Shippingheight.The
refrigeratorscanbe
adjustedtofit intoa
cutoutthatis 83-1/2"
min.to84-1/2"max.

83-1/2"

atRear

72"Frame

toFrame '

28-11/16"

DepthIncluding

Handles

Product Clearances
These refrigerators are equipped with a 2-position

door stop. The factory set 130 ° door swing can be
adjusted to 90 ° if clearance to adjacent cabinets

or walls is restricted.

25"_

Min.toi 130° Door

Wall

I

/L

Width

0 ,!

Swing Swing

H 130° Door

11

q-' '-F

i L

Notethatthetopcase

trimatthefrontis 1/2"

higherandwilloverlap
uppercabinetryor

soffit.Uselevelinglegs

andwheelsfora
maximum1"height

adjustment.

__25"__I

Min.to

Wall

/,,

,, "":::",,:::,,::::!

Additional Specifications
cA separate 115 volt 60Hz., 15 or 20 amp power

supply is recommended for each product, An
individual properly grounded branch circuit or
circuit breaker is recommended. Install properly
grounded 3-prong electrical receptacles recessed

into the back wall, Electrical must be located on
rear wall as shown,

NOTE: GFI (ground fault interrupter)is not
recommended.

Both water lines can enter the opening through

the floor or back wall. Route GE SmartConnect"
kit or 1/4" O.D. copper tubing between the cold

water line and the water connection location.
The tubing should be long enough to extend to

the front of the refrigerator. Installation of an
easily accessible shut-off valve in the water
line is required.

Allow 25" minimum clearance for a full 130° door
swing. Allow 15" for pan removal.

5" minimum clearance is required when door swing
is adjusted to 90°, Ifthe 90° door stop position is
used, pan access is maintained, but pan removal

is restricted.

See illustrations on pages
4 and 5 to determine door

swing interaction with
adjacent cabinets or
countertops,

90° Door 123-7/8"

Swing / Behind

, !, _Frame

L! i

T

!i 36-3/4-

90o.........

5" Minimumto

Wall

Refrigerator

Design Guide

23-7/8"From

Rearof

Refrigerator

Frameless Cabinets: The case trim
overlaps cabinets at the top and sides.

Therefore, frameless cabinets mag require
filler strips to prevent interference with
cabinet door swing. The opening must
allow for filler strips.

Case

Trim

_J 1/2"

1/4"

3/4"

1-3/4" 2-3/4"

1-1/2" 2-1/2"

1-1/4"

.

2-1/4"

3/4" Overlay

Panel

",, (NominalSize)

Top View

130° DOOR SWING

(factorg setting)
Scale 1:1

Door

1-1/4"

Design Guide

- Frameless Cabinets- The
case trim overlaps cabinets

at the top and sides.

Refrigerator Therefore, frameless

J_ CaseTrim cabinets mag require

J .......... filler strips to prevent

I interference with cabinet

I door swing. The opening

t must allow for filler strips.

\ -- ] FromRearof

_°23-7/8"

i.... ',--- ',.... ,,-- 1/4

iq:i.....u

_"_._ L

I I ! ............. 1-1/2"

E_

I I ;;;;;;;;! ',
Jl ',
I I

II

I I !

I I
I I ::::} ',

I I

I I
II

Jl Door
I I I
I I I

II
I I

II '

II .......

LI i

Ill , 3/4Overlay

I] Pane

I I

Top V0ew II

90 DOOR SWING II , .........

(opbonal setting) II , u

scale 1:1 , 1-1/4"

• , ,

@ i i

II I ', '

•

II I i "

II

j i i i

i ! i

, , NominalSize

i

i i

............. 1-1/4

I

, .

5

Installation Instructions

TOOLS REQUIRED

• Tinsnips to cut banding

• Stepladder

• Bucket

• Level

• Appliance dollg
+ Tubing cutter
+ 7/16" open-end wrench

• #2 Phillips screwdriver

• Drill and appropriate bits

• 5/16",7/16" socket
Safetgglasses

1-1/4" and 1/2" open-ended wrench

• Pliers

,, !/4" ratchet or 1/4" angled wrench

HARDWARE SUPPLIED

• Water filter bgpass plug

• Anti-Tip brackets

,, 1/4"nut and ferrule

TRIM SUPPLIED

A. Soffit vent top

13. Left inside case trim

C. Right inside case trim
D. Center U-shape trim
E. Grille base wrap
F. Grille panel

G. Toekick
H. Foam spacer pads

I. Phillips screws
g. Package of 12 plastic spacers

MATERIALS REQUIRED

,, 71" long 2x4 for Anti-Tip support

• 1/4" copper water line tubing or two GE
SmartConnect +' Refrigerator Tubing kits

• Two water shut-off valves

• Screws to secure refrigerator to cabinetrg

• Stick-on hook and loop fastener strips for 1/4"
side panels

FLOORING

For proper installation, this refrigerator must be
placed on a level surface of hard material that is at
the same height as the rest of the flooring. This
surface should be strong enough to support a fullg
loaded refrigerator, or approximatelg 2,400 Ibs.

NOTE: Protect the finish of the flooring. Cut a large
section of the cardboard carton and place under the
refrigerator where gou are working.

A

D C

G F E <_'-

GROUNDING THE REFRIGERATOR

IMPORTANT--(Please read carefullyl

FOR PERSONAL SAFETY,THIS APPLIANCE MUST BE
PROPERLYGROUNDED.

The power cord of this appliance is equipped with
a 3-prong (grounding) plug which mates with a
standard three-prong (grounding) wall receptacle
to minimize the possibilitg of electric shock hazard
from this appliance.

Have the wall outlet and circuit checked bg a
qualified electrician to make sure the outlet is
properlg grounded.

Where a standard 2-prong wall outlet is encountered,
it is gour personal responsibilitg and obligation to
have it replaced with a properlg grounded 3-prong

wall outlet.

DO NOT, UNDER ANY

CIRCUMSTANCES, CUT
OR REMOVE THE THIRD

(GROUND) PRONG FROM
THE POWERCORD.

DO NOT USE AN ADAPTER PLUGTO CONNECT THE
REFRIGERATORTO A 2-PRONG OUTLET.

DO NOT USE AN EXTENSION CORD WITH THIS

APPLIANCE.