Page 1
MONOGRAM 36" PROFESSIONAL
GAS RANGETOP WITH 6 BURNERS
ZGU366NTSS (NATURAL GAS)
BURNER PERFORMANCE
Front Left Burner Element 23,000-BTU
Back Left Burner Element 18,000-BTU
Front Middle Burner Element 15,000-BTU
Back Middle Burner Element 15,000-BTU
Front Right Burner Element 23,000-BTU
Back Right Burner Element 18,000-BTU
VERSATILE GAS BURNER CONFIGURATION
Delivering exceptional cooking flexibility, the two 23,000-BTU
multi-ring brass burners and dual-stack burners offer a range of
heat settings, from gentle simmer to intense fla me
3-PIECE GRATES WITH REVERSIBLE WOK FEATURE
Designed to adapt to different cooking styles, these reversible
grates a re flat on one side a nd uniquely contoured on the other to
perfectly fit round-bottom woks
RING-LIT KNOBS
Delivering a modern approach to accent lighting, the rings
illuminate to indica te when a burner is in use
SOLID BRASS BLADES ON PRECISION MACHINED
KNOBS
With an unma tched attention to deta il, all knobs on the new
Monogram Pro ra nges and ra ngetops come with solid brass
accents
SEAMLESS STAINLESS TOP FRAME
Meticulously crafted from one piece of sta inless steel that covers
the cooktop and control pa nel, this seamless a nd stylish surface is
easy to clean a nd beautiful to look a t
LP CONVERSION KIT INCLUDED
Designed to deliver a sea mless conversion experience, this selfcontained kit includes everything needed to convert a rangetop to
liquid propane
For questions about your
appliance, please call 1-800-626-2000.
PAGE 1 OF 4
Product Specication Created 12/20
Page 2
OVERALL DIMENSIONS
SPECIFICATIONS
Overall Width 35 7/8" (91.1 cm)
Overall Depth 27 1/2" (69.8 cm)
Overall Height 8 1/2" (21.6 cm)
Volts/Hertz/Amps 120v; 60Hz; 15A
Net Weight 135 lbs (61.2 kg)
Approx. Shipping Weight 163 lbs (74 kg)
ATTENTION ELECTRICIAN:
Rangetops must be supplied with 120V, 60Hz, and
connected to an individual, properly grounded branch
circuit protected by a 15 amp circuit breaker or
time-delay fuse.
For more details refer to the installation instructions
for this product.
8-1/2"
Height
35-7/8" Width
27-5/8" to
Front of
Bullnose
29-1/8"
To front of control knobs
27-5/8"
To front of bullnose
8"
Countertop
Level
†
Include the overhang of the rear trim when countertop continues behind the product.
The overhang is decorative only. The weight of the rangetop is fully supported by the side trims.
** Maximum countertop cutout depth from the back of the rear trim to the back edge of chamfer at
the sides of the control panel - typically, the maximum countertop cutout depth (front to back).
Minimum countertop cutout depth is 25-1/4"
Rear finished edge of the
control panel
23-5/8"
**26-7/8"
To front of
control panel
6-1/2"
7-1/4"
8-1/2"
Height
5-1/4"
To pipe
stub center
1"
1/2"
Countertop
Level
†
3/16"
11/32"
1-3/16"
For questions about your
appliance, please call 1-800-626-2000.
Dimensions in parentheses a re in centimeters unless otherwise noted.
Actual product dimensions may vary due to ma nufacturing tolerances.
PAGE 2 OF 4 Product Specication Created 12/20
Page 3
DIMENSIONS AND INSTALLATION
INFORMATION (IN INCHES)
** As defined in the National Fuel Gas Code (ANSI Z223.1/CSA
B149.1, Current Edition). Cleara nces from non-combustible
materials a re not part of the ANSI Z21.1/CSA 1.1 scope and a re not
certified by CSA. Cleara nces less than 12” must be approved by local
codes and/or the a uthority having jurisdiction.
UTILITY LOCATIONS
HELPFUL TIPS
PRODUCT DIMENSIONS AND
CLEARANCE
A 36"- or 42"-wide professional vent hood
is recommended for installation over this
rangetop.
Cleara nces between rangetop and side wall
must be at least 12" on each side.
Allow 8" free space below the top surface of
countertop. Allow additional cleara nces below
the burner box to install the regulator a nd
make house gas supply connections. Use a 90°
elbow to route the gas connections and limit
interference with drawers or other cabinetry.
* e opening between a 4" high backsplash
must be 36" to allow the rangetop to slide back
against the wall.
* *As defined in the National Fuel Gas Code
(ANSI Z223.1/CSA B149.1, Current Edition).
Cleara nces from non-combustible materials
are not pa rt of the ANSI Z21.1/CSA 1.1 scope
and a re not certified by CSA. Clearances less
than 12” must be approved by local codes a nd/
or the authority having jurisdiction.
GAS PRESSURE REGULATOR
You must use the gas pressure regulator supplied
with this rangetop. For proper opera tions the
inlet pressure to the regulator should be as
follows:
Natural Gas:
Minimum pressure: 6” of Water Column
Maximum pressure: 13” of Water Column
Propane (LP) Gas:
Minimum pressure: 11” of Water Column
Maximum pressure: 13” of Water Column
See installation instructions for more deta ils
WARNING
Installations without a hood require 48"
minimum to combustibles above the
rangetop. A custom hood installa tion with
exposed horizontal combustible surfaces
must have an "a uto-on" feature. Refer to
hood installation instructions for specific
hood cleara nces. e surface of the entire
back wall above the countertop a nd below
the hood must be covered with a noncombustible material such as metal,
ceramic tile, brick, ma rble or other stone.
For questions about your
appliance, please call 1-800-626-2000.
PAGE 3 OF 4 Product Specication Created 12/20
Page 4
DIMENSIONS AND INSTALLATION
INFORMATION (IN INCHES)
Rangetop
Front of deep cabinets can align with
control panel beveled edge.
Rangetop
1/2" Above Adjacent
Countertops
1/2" Above Adjacent
Countertops
HELPFUL TIPS
OPTIONAL BACKSPLASH
ACCESSORIES
• e rangetop requires a 12" minimum
cleara nce to a vertical combustible surface
at the rea r. A backsplash is required for
installations with less tha n 12" clearance. e
following backsplash accessories are ava ilable,
or a custom, non-combustible backsplash ca n
be used.
• Order one with a 36"-wide ra nge backsplash:
• UX12BS36PSS–12"-height backsplash
• UXADBS36PSS–30"-36" adjustable-height
backsplash with warming shelf
Control panel projects forwards from
standard depth cabinets.
SIDE VIEW WITH A BACKSPLASH
For questions about your
appliance, please call 1-800-626-2000.
PAGE 4 OF 4 Product Specication Created 12/20
Loading...