30" Professional range
BACK FRONT BACK FRONT
TIMER
PUSH TO
SELECT
O
F
F
B
A
K
E
B
R
O
I
L
P
R
O
O
F
R
O
A
S
T
B
R
O
I
L
B
A
K
E
C
O
N
V
.
C
O
N
V
.
C
O
N
V
.
General features
Authentic Professional appearance.
smoothly finished edges, large electronic control knobs and
heavy-duty handles.
Sealed, dual-flame stacked burners. Provide complete
low-simmer-to-rapid-boil flexibility (140°F simmer to 18,000
BTUs*). The burners are sealed to the recessed cooktop for
easy cleaning.
Monogram® Professional Reverse-Air convection oven.
Provides superb baking results, with fast preheating.
Heavy-duty, full-extension racks. Glide smoothly in and
out on stainless steel ball bearings for easy access, and are
designed to remain in the oven during the self-clean cycle.
LED task lights. Positioned below the bullnose, these lights
provide a functional and theatrical touch.
Electronic ignition with automatic reignition. Ensures a
continuous flame and reignites automatically if accidentally
extinguished.
Reversible burner grates. These grates are flat on one
side and uniquely contoured on the other to accommodate
round-bottom woks.
For additional details on product installation, warranty
coverage, care and maintenance, visit monogram.com.
*Natural gas
Stainless steel with
30" Professional range
Dual-fuel: ZDP304NPSS (natural gas) and
ZGP304LPSS (liquid propane)
All-gas: ZDP304NRSS (natural gas) and
ZGP304LRSS (liquid propane)
Overall dimensions
(WxHxD in inches):
29-7/8 x 35-1/4–36 -3/4 x 26-3/4
Amps @240VAC 26
208VAC 22
KW Rating
@240VAC 6.1
208VAC 4.6
Approx. shipping wt. (lbs.) 425
•
Professional ranges are available in both
a dual-fuel and all-gas model
•
Dual-fuel or all-gas range must be
specified by model number
•
Natural or LP gas must be specified by
model number
•
Optional 12" or 30"–36" adjustable-height
backsplash accessories
•
All burner grates are reversible to support
a round-bottom wok
Advance planning for 30" dual-fuel Professional range
All Professional ranges offer a number of choices in size and
cooktop configurations.
The ranges are factory set for natural gas or liquid propane. Be
sure to order the correct model for the installation situation. If
the wrong fuel type is ordered, the range may be converted.
Conversion orifices are packed with each product.
WB28K10553 high-altitude kit is available for operation above
6,000 feet. This kit includes orifices for both LP and natural
gas operation.
All conversion kits must be
installed by a qualified
service technician
at an additional cost.
12
Locate gas
and electrical
as shown.
Electrical requirements
Ranges must be supplied with 208/240V, 60Hz, and connected
to an individual, properly grounded branch circuit protected by a
circuit breaker or time-delay fuse. Install a 30-amp circuit for 30"
ranges. The receptacle must be a NEMA 14-50R device to accept
the four-prong plug on the range.
Gas supply
• Natural gas models are designed to operate at 5" water column
pressure. For proper operation, the pressure of the natural gas
supplied to the regulator must be between 7" and 13"
water column.
• The liquid propane models are designed to operate at 10" water
column pressure. For proper operation, the pressure of the LP
source to the regulator must be between 11" and 13"
water column.
Advance planning for 30" all-gas Professional ranges
28-7/8”
All Professional ranges are factory set for natural or liquid
propane gas. The correct model should be ordered for the
installation situation.
Conversion kits are included with the range if the wrong gas
type was ordered. WB28K10553 high-altitude kit for operation
above 6,000 feet is also available. The kits must be installed by
a qualified service technician at additional cost.
Locate gas
and electrical
as shown.
Electrical requirements
Ranges must be connected to a 120V, 60Hz properly grounded
dedicated circuit protected by a 15-amp circuit breaker or
time-delay fuse.
Gas supply
• The natural gas models are designed to operate at 5" water
column pressure. For proper operation, the pressure of the
natural gas supplied to the regulator must be between 7"
and 13" water column.
• The LP models are designed to operate at 10" water column
pressure. For proper operation, the pressure of the LP gas
supplied to the regulator must be between 11" and 13"
water column.
Backsplash accessories
The range requires a 12" minimum clearance to a vertical
combustible surface at the rear. A backsplash is required
for installations with less than 12" clearance. The following
backsplash accessories are available, or a custom, noncombustible backsplash can be used.
Order ZX12B30PSS, 12" backsplash
Order ZXADJB30PSS, 30"-36" adjustable-height backsplash
with warming shelf
Side view with a backsplash
to Front
Control Panel
28-1/4” to
Beveled
Edge of Control
Panel Bullnose
27-1/2” to
Beveled Edge
- Maximum
Adjacent
Cabinet Depth
Flush
Installation
28-1/4”
to Front of
Door
Edge
3-3/16”
Depth
for
to Front of
31-1/16”
Handle
48-1/4”
with Oven Door
Open
7” Control
Panel Height
Optional
Backsplash
Accessories
30-36”
35-1/4”
to
36-3/4”
10-1/2”
13/16”
12”
1-1/2”
Product dimensions and clearances
Additional clearances
Installations without a hood require 48" minimum to combustibles.
A custom hood installation with exposed horizontal combustible
The serial and model numbers are located behind the far left
knob for convenience. The full rating label is located on the
bottom of the control panel—visible when the oven door is open.
surfaces must have an “auto-on” feature. See hood installation
instructions for specific hood clearances.
The surface of the entire back wall above the range and below
the hood must be covered with a non-combustible material such
as metal, ceramic tile, brick or stone.
14
Loading...