GE ZGG420NBPSS User Manual

Page 1
Built-in outdoor grills
monogram.com
42" built-in outdoor grill
ZGG420NBPSS (natural gas)
Overall dimensions (WxHxD in inches): 41-7/8 x 26 x 27
Approx. shipping wt. (lbs.) 334
23,000-BTU ceramic-infrared
sear burner
25,000-BTU stainless steel
burners
Red LED lights above the
knob controls
Halogen interior lighting
Ceramic-infrared rotisserie
burner
30" built-in outdoor grill
ZGG300NBPSS (natural gas)
Overall dimensions (WxHxD in inches): 29-7/8 x 26 x 27
Approx. shipping wt. (lbs.) 253
23,000-BTU ceramic-infrared
sear burner
25,000-BTU stainless steel
burners
Red LED lights above the
knob controls
Halogen interior lighting
Ceramic-infrared rotisserie
burner
General features
Heavy-duty, 304 stainless steel construction with Professional styling complements Monogram®
ranges and other cooking products, allowing a seamless transition between indoor and outdoor spaces.
Double-wall design insulates the canopy to minimize heat loss and allow for cooler surfaces.
25,000-BTU stainless steel burners offer precise temperature control, and the Gourmet Radiant
trays ensure even heat distribution and reduce flare-ups.
Ceramic-infrared rotisserie burner allows you to slow-roast meats to succulent perfection. The rotisserie motor assembly plugs in and detaches easily for convenient cooking and storage.
23,000-BTU ceramic-infrared searing burner delivers the high radiant heat needed to sear the outside of foods, locking in natural juices and flavors.
Integrated illumination sets the stage for nighttime grilling with red LED lights above the knob controls, along with interior halogen lighting.
Grill liners are required for installation in a combustible enclosure. Order separately, ZX30JR for 30" grills and ZX42JR for 42" grills.
Built-in grills
Dual-burner cooktopFree-standing grills
69
Page 2
Advance planning for built-in outdoor grills
12" Min. to Combustibles
These grills are factory set for natural gas operation. A conversion kit is available if liquid propane is preferred; order WB28X10117.
High-altitude kit WB28X10119 is available for operation above 2,000 feet. Order WB28X10118 to change the connection from LP portable (20-lb. tank) to whole-house stationary tank or to change a stationary tank to portable.
Conversion kit must be installed by a qualified service technician at additional cost. Order this kit from your Monogram
®
supplier.
Side view, all built-in grill models
10-1/4" from
Bottom of
Support Flange
*25-1/2"
Countertop Depth
27" to Front
of Control Panel
28-1/2" to Front of Bullnose
*The weight of the grill is fully supported by
the side trims. The back of the grill overlaps the back edge of the cutout.
42"-wide built-in grill ZGG420NBPSS
12" Min. to Combustibles 4" Min. Clearance for Lid
to Non-Combustibles
40-3/4"
24-1/2"
Grill Cutout
36"
1-1/8" Min.
Min.
30"-wide built-in grill ZGG300NBPSS
4" Min. Clearance for Lid
27"
Gas and Electrical Locations
10-7/8"
Opening for Optional Access Doors
to Non-Combustibles
26"
41-7/8"
26"
70
24-1/2"
28-3/4"
36"
Min.
Grill Cutout
1-1/8" Min.
Gas and Electrical Locations
27"
10-7/8"
Opening for Optional Access Doors
29-7/8"
Page 3
Advance planning for built-in outdoor grills
monogram.com
These grills are designed to be installed into a non-combustible enclosure when not using grill liner accessories.
• The grill drops into the opening and hangs from the side flanges. It does not require support from the bottom.
• The cutout must be completely covered with non-combustible
material such as stone, brick, ceramic tile, concrete board, etc. The countertop surface and edges must be flat and level.
• If the countertop has an overhang, it must be notched
Countertop Notch Detail
Depth to
Cabinet Face
or cut back flush with the front face of the cabinet below.
• Allow at least 12" minimum
clearance at the back of the grill when the exhaust is directed to a window or surface that is
1-1/2" Depth
5/8" for Outdoor Grills
difficult to clean. Allow at least 4" clearance behind the grill to allow the hood lid to open.
• Allow 12" minimum clearance on both sides and the back of
the grill to adjacent vertical combustible construction.
• These gas grills cannot be used below any type of overhead
construction.
• These grills are designed for outdoor use only. Do not locate
the grill or cooktop in a building, garage or other enclosed or semi-enclosed area.
• Locate the back side of the grill away from prevailing winds
and avoid cooking in windy conditions.
Installation in a combustible enclosure
To install into combustible enclosures, built-in outdoor grills must use a grill liner accessory. Please refer to the grill liner installa­tion instructions for details.
Insulated Liner
Built-in grills
Dual-burner cooktopFree-standing grills
Dimensions and installation information (in inches)
Built-in grill cut-out dimensions to install into combustible enclosures with grill liner accessory (not provided with built-in grill)
ZGG420NBPSS (natural gas)
Description
30" grill liner ZX30JR 36" 5" 26-1/2" 4-1/2" 3 11-5/8" 42" grill liner ZX42JR 48" 5" 26-1/2" 4-1/2" 3 11-5/8"
Kit model
number
a b c d e f
Dimensions with
insulated jacket installed
4" square holes for gas and electrical connections both left and right sides (rear or bottom access). Make these holes in the frame based on your requirements.
Combustible Enclosure
71
Page 4
Advance planning for built-in outdoor grills
ZX27AD, Double access doors
Double access doors may be installed directly below a grill. The support frame fits into the opening and the doors hang from side hinges.
When installing into an enclosure and adjacent to other accessories, measure and cut the openings to align them evenly across the bottom. The access door frame overlap at the bottom of the cutout is 7/8". See cutout dimensions below.
72
Loading...