Installation
Instructions
Free-Standing Side-by-Side
Stainless Steel Refrigerator
ZFSB23DSS
Monogram:
Safety Information
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•IMPORTANT- S ,vetheseinsnuctions
fl)r local inspect(n"s use.
•IMPORTANT- Obse,ve ,llg,,ve,', ing
codes and ordinances.
• Note to Installer - Be sure to leave these
instructions with the (_onsumer.
• Note to Consumer - Kee I) these instructions with
wmr Owner's Manual for flmue refl_rence.
WARNING:
This appliance nlust be properly grounded. See
"Grounding the Refrigerator," page 4.
AVERTISSEMENT :
Cet appareil doit &tre correctement mis _'_la terre.
Consulter <_MiNe _'lla terre du r_frig(_rateur, >, I)age, 4.
If you received a damaged refri,*erator you should
immediately contact your dealer or builder.
Skill Level - Installation of this refl_igerator requires
basic mechanical, carl)entry and I)lumbing skills.
Proper installation is the responsibility of the installer.
Product tailure due to improper installation is not
covered under the GE Appliance Warranm See the
Owner's Manual fin" warranty information.
CAUTION:
Due to the weight and size of this refrigerator, and to
reduce the risk of personal ii_im T (>r damage to the
product - T_40 PEOPI,E ARE REQUIRED FOR
PROPER INSTAI,LATION.
PRUDENCE:
_ cause du poids et de la taille de ce r_frig&'atem" et
pour r_duire le risque de blessure et de dommages,
li, E&UT DEUX PERSONNES POUP, EMRE
I,'INSTAI,LATION CORRECTEMENT.
WARNING:
• Use this appliance only fl)r its intended i)urpose.
• hmnediately repair or replace electric service cords
that become frayed or damaged.
• Unplug the reli'igerator before cleaning or making
repairs.
• Repairs should be made by a qualified service
technician.
AVERTISSEMENT :
• ll ne taut utiliser cet appareil que pour l'utilisation
aI)I)ropri_e.
• R_parer ou remplacer imm_diatement tout cordon
_lectrique ettiloch_ ou endommag_.
• I1 taut d_brancher le r_frig&'atem" avant le
nettoyage ou route intervention.
• I,es r_parations doivent &tre taites par tm
technicien qualifi_.
CONTENTS
Plamting Information
Product Dimensions and Clearances .............................. 3
The h_stallation Space ...................................................... 3
Installation Instructions
Tools, Hardware, Materials .............................................. 4
Grounding the Refl'igerator ............................................ 4
Step l, Move Refl'igerator Indoors .................................. 5
Step 2, Install X4'ater I,ine ................................................. 6
For Monogrmn local service in your area, call
1.800.444.1845.
For Monogrmn service in Canada, call
1.888.880.3030
For Monogram Parts m_d Accessories, call
1.800.626.2002.
www. monogram.com
Step 2A, RO Water i,ine ................................................... 7
Step 3, Connect Water Supply ......................................... 7
Step 4, Connect Power. .................................................... 7
Step 5, Move Refrigerator Into Position ......................... 7
Step 6, i,evel Reti'igerator ................................................ 8
Step 7, Align Doors ........................................................... 8
Step 8, Start Icemaker. ..................................................... 9
Step 9, Temperature Controls ......................................... 9
Step 10, Install Toekick .................................................... 9
Planning Information
PRODUCT DIMENSIONS
AND CLEARANCES
27-1/2"
36"
29-1/2"
Including
Handles
This Molmgram fl'ee-standing refl'igerator requires
the fi_llowing clearances fi)i" i)roper air circulation,
phunbing and electrical connections.
Air Circulation Clearmaces:
• 1/8" on each side
• ]" at tile top
• 1" at tile back
Installation in a corner:
• Allow 4" clearance on each side to an a_!jacent wall
fl)r a 90 ° opening and access to drawers.
14-1/4"
160° Door Swing
90° Door Swing
THE INSTALLATION SPACE
Tile opening width must be 36-1/2".
_S6-1/2"_
WallView
Electrical
73"min.
Water And Electrical Locations
Tile oi)ening inust be i)rei_ared with tile electrical and
water sui)ply located as shown.
Additional Specifications
• A 115 w)lt 60Hz., 15 or 20 amp power suI)ply is
required. An individual i)roperly grounded branch
circuit or circuit breaker is reconm_ended. Install
a i)roi)erly grounded 3-i)rong electrical receptacle
recessed into the back wall.
NOTE: GF] (ground fimlt interlui)ter ) is not
recoil] i_lended.
• Water line can enter the oi)ening through the floor
or through an a(!jacent cabinet, as close to the back
wall as possible. The water line should be 1/4" O.D.
COl)per tubing between the cold water line and
water Colmection location at the rear of the
refl'igerator, h_stallation of an easily accessible
shut offwflve in the water line is reconm_ended.
Area
i t. 4L ,J
• On tile freezer side, allow 14-1/4" inin. clearance
for removal of ice bin.
• On the fresh food side, allow 19" nfin. clearance
to wall for rein owfl of drawers.
"-7" =
II k 1
=a i x i
, =
3
Installation Instructions
TOOLS REQUIRED
• Tinsnips to cut banding
• Stepladder
• Bucket
• I,evel
• Appliance Hand Truck
• Tubing cutter
• #9 Phillips screwdriver
• Drill and al)l)ropriate bits
• 3/8", 5/16" and 7/16" socket
•Satety glasses
MATERIALS REQUIRED
• 1/40.D. compression nut and 2 ferrules (sleeves)
GROUNDING THE REFRIGERATOR
IMPORTANT - (Please read carefully)
FOR PERSONAl, SAFETY, THIS APPI,IANCE MUST
BE PROPERLY GROUNDED.
The power cord of this appliance is equipped with
a 3-prong (grounding) plug which mates with a
standard 3-prong (grounding) wall receptacle to
minimize the possibility of electric shock hazard from
this appliance.
Haxe the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
I)to I)erlx,,gr°unded
FLOORING
For proper installation, this refrigerator must be placed
on a level surface of hard material that is at the same
height as the rest of the flooring. This surface should be
strong enough to sui)port a flflly loaded refl'igerator.
IMPORTANT NOTE: Protect the finish of the flooring.
Cut a large section of the cardboard carton and place
trader the refrigerator where you are working.
DO NOT, UNDER ANY
CIII(3_5MSTANCES, CUT
OR REMOVE THE THIRD
(GROUND) PRONG
FROM THE POWER CORD.
DO NOT USE AN ADAPTER PI,U(; TO CONNECT
THE IIEFRIGERATOR TO A 2-PRON(, OLTI,ET.
DO NOT USE AN EXTENSION CORD X41TH THIS
APPI,IANCE.
Where a standard 2-prong wall outlet is encountered,
it is your personal responsibility and obligation to
have it replaced with a properly grounded 3-prong
wall outlet.
4
Loading...