GE ZDW24 BB, ZDB24 WW, ZDW24 WW, ZDB24 BB User Manual
GE Monogram
Installation
Instructions
®
www.monogram.com
Beverage Center
Model
ZDB24 WW
ZDB24 BB
Wine Chiller
Model
ZDW24 WW
ZDW24 BB
CAUTION
WARNING
Important Information
Beverage Center & Wine Chiller
Before you begin—Read these instructions completely and carefully.
IMPORTANT: Save these instructions for local inspector’s use.
IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions with your Owner’s Manual for future refer-
ence.
This appliance must be properly grounded. See “Electrical Supply”, page 4.
CAUTION
ATTENTION
If you received a damaged beverage center or
wine chiller, you should contact your dealer.
Proper installation is the responsibility of the
installer. Product failure due to improper
installation is not covered under the GE
Appliance Warranty. See the Owner’s Manual
for warranty information.
For Monogram local service in your area,
1-800-444-1845.
For Monogram service in Canada
1-888-880-3030.
For Monogram Parts and Accessories, call
1-800-626-2002.
Cet appareil doit être correctement mis à la terre.
Consulter « Alimentation électrique », page 4.
WARNING
• Use this appliance only for its intended
purpose.
• Immediately repair or replace electric
service cords that have become frayed or
damaged.
• Unplug the beverage center or wine
chiller before cleaning or making repairs.
• Repairs should be made by a qualified
service technician.
ATTENTION
• Il ne faut utiliser cet appareil que pour
l’usage pour lequel il a été construit.
• Il faut réparer ou remplacer
immédiatement tout cordon
d’alimentation électrique effiloché ou
endommagé.
• Débrancher le bar ou le réfrigérateur
à vin avant le nettoyage ou toute
intervention.
• Les réparations doivent être faites par un
technicien qualifié.
Contents
2
Design Information
Models Available.................................................................................................................................. 3
Dimensions and Clearances ............................................................................................................... 3
Installation Preparation
Grounding the Beverage Center or Wine Chiller ............................................................................ 4
Reverse Door Swing ............................................................................................................................ 5
Installation
Step 1: Remove the Packaging ........................................................................................................... 6
Step 2: Install Handle ......................................................................................................................... 6
Step 3: Install Leveling Legs ............................................................................................................... 7
Step 4: Slide the Unit into the Cutout ............................................................................................... 7
Template for nameplate location ...................................................................................................... 8
Design Information
Locate
Outlet
34-1/2"-35"
24" Min.
24" Min.
5"
34-1/2"
24-1/8"
23-7/8"
Beverage Center & Wine Chiller
Models
Available
Dimensions
& Clearances
ZDB24 WW
White Beverage Center
ZDB24 BB
Black Beverage Center
ZDW24 WW
White Wine Chiller
ZDW24 BB
Black Wine Chiller
Front ventilation allows the beverage center
or wine chillder to be installed as a built-in
and still operate efficiently.
The bottom front grille area must remain
unobstructed for proper air circulation and
operation.
Cutout dimensions shown allow for a full door
swing and access to the pull-out racks.
The Monogram beverage center or the wine
chiller adds an eloquent statement of style,
convenience and flexibility.
The Monogram beverage center and wine
chiller can be used freestanding or as a
built-in.
Installation
Options
Increase storage capacity by installing two
Monogram beverage centers side by side or
two Monogram wine chillers side by side.
Or, install a Monogram beverage center next
to a Monogram wine chiller for a complete
refreshment center.
A side by side installation requires a 48" wide
opening. No trim kits required.
• The glass door fronts should align evenly
with adjacent cabinet door fronts.
Frameless Cabinets:
• If installing between frameless cabinets, a
1/2" wide filler strip or side panel may be
required. The filler strip will act as a spacer
between the door case and adjacent cabinet
and will prevent interference with cabinet
door swing. The width of the opening must
include filler panels.
Provide two separate properly grounded
electrical outlets for a side by side installation.
Each electrical outlet should have a voltage
rating that matches the rating plate.
3
Loading...