GE ZBD7000G00II, ZBD7000G01II, ZBD7000G03II, ZBD7000G04II, ZBD7000G05II Installation Guide

Ilnstruct ons

Installation

ZPRO7000S

Professional Style

Stainless Steel Door Panel Kit

For ZBD7000GII and ZBD7005GII

[] Laythe dishwasher on its back.
[] Secure the panel to the door by inserting the top

and bottom shoulder washers into the matching
keyhole slots. Make sure all 4 washers engage the
keyhole slots.

Stainless

Press the panel againstthe door and push downwards

[]

until the washers are fully engaged into the keyhole slots.
The panel should align evenly with the top and sides,

Stand the dishwasher upright.

[]

Open dishwasher

[]

door and drive

the supplied
#6 x 2 Phillips

screws through

the inner door

and into the f_
panel. Drive

one screw at

the top and then

one screw on each
side as shown. Stainless

Door springs must be

[]

installed in the correct position.

Position Left Side Riqht Side

Front N/A Blue
Rear Green Green

See Spring Removal instructions below.

SteelPanel

TO REMOVE THE SPRING AND SPRING SUPPORT ROD

[] Close the door and lift the bottom of the support rod

upward and away from the slot in the door hinge.

[] Pull the rod downward from the guide in the

side plate.

[] Remove the spring and spring sleeve from the rod.
[] Reassemble in reverse order.
NOTES:

• The front spring sleeves and support rods are different
from the rear ones. When comparing the two support

rods, the front rods have two extra 5/32" diameter

round lugs approximately 1/3 of the way along the rod;
the rear rods do not have these lugs. The external
spring sleeve for the front spring assembly is the

longer of the two. If the front rod and front sleeve are

installed in the rear position, the door will not open all
the way and the rod is likely to come off when the door

is closed, Make sure the correct assemblies are

reinstalled in the correct positions.

Pub,No,31-30573 ]
PartNo,20601559Pl13

03-04JR
Printedintile UnitedStates

]

• Take care notto damage the interior lighttrigger
operated by the right hand front support rod.

• A spring and support rod must always be present in the

right hand front position to activate the light trigger,

LightTrigger

Viewing
Hole