GE WPXH214ACC, WPXH214AWW Specification
TM
WPXH214ACC/WW – GE Profile™ ENERGY STAR 3.1 Cu. Ft. Extra-Large Capacity Front-Loading Washer
Dimensions (in inches)
26-3/4 |
|
|
REAR VIEW |
|
11-3/4 |
2-7/8 |
17 |
|
60 |
|
|
|
||
|
|
3/4 |
24-3/4 |
1 |
36 |
|
|
|
|
Under |
Water |
|
|
1-1/2 |
Counter |
Inlets |
|
|
|
|
|
Power |
||
34-5/8" |
31-5/8" |
|
|
|
|
|
|
|
Cord |
|
|
|
|
33-1/2" |
Roller Wheels
REAR VIEW |
Adjustable Legs |
SIDE VIEW
Circuit Requirements: An individual, properly-grounded branch circuit, with a three-prong grounding-type receptacle, protected by a 15 or 20 amp circuit breaker or a time-delay fuse, is required.
Electrical Rating: 120V, 60Hz, 12.0A
See Installation Instructions, packed with the product, for complete dimensional data.
Listed by
Underwriters
RLaboratories
As an ENERGY STAR® partner, GE has determined that this product meets the ENERGY STAR guidelines 
for energy efficiency.
|
For answers to your Monogram,® GE Profile™ or |
|
GE appliance questions, visit our website at |
|
GEAppliances.com or call |
Specification Revised 7/05 |
GE Answer Center® service, 800.626.2000. |
260202
TM
WPXH214ACC/WW – GE Profile™ ENERGY STAR 3.1 Cu. Ft. Extra-Large Capacity Front-Loading Washer
Free-Standing Installation
36"
25-3/4"
53-1/2"
Stacked Installation
70-5/8"
25-3/4"
26-3/4"
Specification Revised 7/05
Raised/Built-In Installation
|
|
|
Wide |
|
x3/4" |
||
High |
|
Sides |
|
3/4" |
|
|
|
|
|
All |
|
|
on |
|
|
Lip |
|
|
|
14''
29'' |
56''-60'' |
|
|
|
Max. |
Undercounter Installation
Countertop
Washer
Top Sheet
Dryer
Top Sheet
Special Installation Requirements
Undercounter Installation
•Accessory mounting kits are required for undercounter installation. To order,
call 1-800-848-7722.
Washer – Order Pub. No. 14-A037 Dryer – Order Pub. No. 14-A008
Stacked Installation
•Brackets for stacking dryer over washer are included with the dryer.
Alcove or Closet Installation
•If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
•The dryer MUST be exhausted to the outdoors.
•Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0" either side 3" front and rear
•Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
•Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.
•The closet should be vented to the outdoors to prevent gas pocketing in case of a gas leak in the supply line.
•No other fuel-burning appliance shall be installed in the same closet with the dryer.
Bathroom or Bedroom Installation
•The dryer MUST be exhausted to the outdoors.
•The installation must conform with the local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.
Minimum Clearances other than Alcove or Closet Installations
•Minimum clearances to combustible surfaces:
0" both sides 3" rear
For more information on venting kits and accessories, please call 1-800-GE-CARES.
|
|
As an ENERGY STAR® |
|
Listed by |
partner, GE has determined |
|
Underwriters |
that this product meets the |
R |
Laboratories |
ENERGY STAR guidelines |
|
|
for energy efficiency. |
For answers to your Monogram,® GE Profile™ or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center® service, 800.626.2000.
260202
Loading...