GE Triton XL EDW4000, Triton XL EDW4060, Triton XL GSD6200, Triton XL GSD6300, Triton XL GSD6600 Owner's Manual

...
EDW4000 EDW4060
GSD6200 GSD6300 GSD6600 GSD6660 GSD6700
Owner’s Manual
Dishwashers
165D4700P233 49-5907-1 09-01 JR
Safety Instructions . . . . . . . 2, 3
Operating Instructions
Care and Cleaning . . . . . . . . . 10
Loading Place Settings . . . . . . . 9
Loading the Racks . . . . . . . . . . 8
Optional Accessories . . . . . . . . .9
Using the Dishwasher . . . . . .6, 7
Troubleshooting Tips . . . 11, 12
Consumer Support
Consumer Support . . .Back Cover
Product Registration . . . . .13, 14
Warranty . . . . . . . . . . . . . . . . . 15
GEAppliances.com
Write the model and serial numbers here:
Model # __________________
Serial # __________________
You can find them on the tub wall just inside the door.
Triton XL
PROPER INSTALLATION AND MAINTENANCE
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING.
WARNING!
For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or death.
2
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
Under certain conditions hydrogen gas may be produced in a water heater that has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE.
If the hot water has not been used for two weeks or more, prevent the possibility of damage or injury by turning on all hot water faucets and allow them to run for several minutes. Do this before using any electrical appliance which is connected to the hot water system. This simple procedure will allow any built-up hydrogen gas to escape. Since the gas is flammable, do not smoke or use an open flame or appliance during this process.
WATER HEATER SAFETY
Use this appliance only for its intended purpose as described in this Owner’s Manual.
This dishwasher must be properly installed and located in accordance with the Installation Instructions before it is used. If you did not receive an Installation Instructions sheet with your dishwasher, you can receive one by visiting our Website at GEAppliances.com.
Connect to a grounded metal, permanent
wiring system; or run an equipment­grounding conductor with the circuit conductors and connect to the equipment­grounding terminal or lead of the appliance.
Improper connection of the equipment-
grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative if you are in doubt whether the appliance is properly grounded.
Use supply conductors rated at least 75°C
(167°F).
Dispose of discarded appliances and shipping
or packing material properly.
Do not attempt to repair or replace any part
of your dishwasher unless it is specifically recommended in this manual. All other servicing should be referred to a qualified technician.
To minimize the possibility of electric shock,
disconnect this appliance from the power supply before attempting any maintenance.
NOTE:
Turning the dishwasher off does not disconnect the appliance from the power supply. We recommend having a qualified technician service your appliance.
DO NOT…
Do not tamper with controls.
Do not abuse, sit on, or stand on the door
or dish rack of the dishwasher.
Do not discard a dishwasher without first
removing the door or removing the door latch.
Do not store or use combustible materials,
gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
Do not allow children to play around
dishwasher when opening or closing door due to the possibility of small fingers being pinched in door.
Do not allow children to play with, on, or
inside this appliance or any discarded appliance.
WARNING!
3
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
GEAppliances.com
PROPER DISPOSAL OF THE DISHWASHER
Junked or abandoned dishwashers are dangerous… even if they will sit for “just a few days.” If you are getting rid of your old dishwasher, please follow the instructions below to help prevent accidents.
Before You Throw Away Your Old Dishwasher:
Take off the door of the washing
compartment or remove the door latch keeper (as shown).
WARNING! RISK OF CHILD ENTRAPMENT
WHEN USING YOUR DISHWASHER
CAUTION: Contents washed in
Anti-Bacteria cycle may be hot to the touch. Use care before unloading.
Use only powder, tabs, liquid detergents or
rinse agents recommended for use in a dishwasher and keep them out of the reach of children. Cascade®, Cascade Complete
®
and Electrasol®Automatic Dishwashing Detergents, and Jet-Dry®rinse agent have been approved for use in all GE dishwashers.
Locate sharp items so that they are not likely
to damage the door seal.
Load sharp knives with the handles up to
reduce the risk of cut-type injuries.
Do not wash plastic items unless marked
dishwasher safe
or the equivalent. For plastic items not so marked, check the manufacturer’s recommendations.
Non-Dishware Items: Do not wash items such
as electronic air cleaner filters, furnace filters and paint brushes in your dishwasher. Damage to dishwasher and discoloration or staining of dishwasher may result.
Do not touch the heating element during or
immediately after use.
Do not operate your dishwasher unless all
enclosure panels are properly in place.
Close supervision is necessary if this
appliance is used by or near children.
Load light, plastic items so they will not
become dislodged and drop to the bottom of the dishwasher—they might come into contact with the heating element and be damaged.
READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.
SAVE THESE INSTRUCTIONS
Door latch keeper
4
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
About the dishwasher control panel.
You can locate your model number on the tub wall just inside the door.
Throughout this manual, features and appearance
may vary from your model.
Control Settings
Status Indicator Lights
The Status display tells you what’s happening while the dishwasher is in operation and may flash, indicating a malfunction (see page 6). The lights will come ONindicating the sequence of operation the dishwasher is in.
SENSING Displayed while the ExtraClean™ Sensor is measuring the amount of soil and temperature of water.
(on some models)
The dishwasher will adjust the selected cycle to achieve optimal performance.
WASHING Displayed during prewash and main wash periods.
(on some models)
RINSING Displayed during rinse periods.
(on some models)
DRYING Displayed during
HEATED DRY
.
(on some models)
SANITIZED Displayed when cycle has met sanitization conditions. Light remains ONuntil door is opened.
CLEAN Displayed when a wash cycle is complete. The light will remain ONuntil door is opened.
ExtraClean™ Sensor Selections
The light above the selected pad will be ON to indicate which ExtraClean™ Sensor Selection has been selected.
ANTI-BACTERIA Heavy 10.0 gal., 93 min.
Medium 8.6 gal., 90 min. Light 7.2 gal., 90 min.
This cycle raises the water temperature in the final rinse to sanitize your dishware. The cycle length will vary depending on the temperature of your inlet water.
NOTE: The Anti-Bacteria cycle is monitored for sanitization requirements. If the cycle is interrupted during or after the main wash portion or if the incoming water temperature is so low that adequate water heating cannot be achieved, the sanitizing conditions may not be met. In these cases, the sanitized light will not illuminate at the end of the cycle.
NOTE: NSF certified residential dishwashers are not intended for licensed food establishments.
POTS Heavy 11.4 gal., 95 min.
& PANS Medium 10.0 gal., 71 min.
Light 10.0 gal., 66 min.
This cycle is meant for heavily soiled dishes or cookware with dried-on or baked-on soils. This cycle may not remove burned-on foods. Everyday dishes are safe to be used in this cycle.
NORMAL WASH Heavy 9.9 gal., 74 min.
Medium 7.0 gal., 61 min. Light 5.6 gal., 48 min.
This cycle is for medium/heavily soiled dishes and glassware.
1
1 5
3
4
2
2
5
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
SPEED CYCLE Heavy 9.3 gal., 36 min. or Medium 7.2 gal., 36 min. SPEED WASH Light 5.7 gal., 33 min.
(on some models)
This cycle is for everyday dishes and glassware.
CHINA CRYSTAL Heavy 10.0 gal., 49 min. (on some models) Medium 7.2 gal., 36 min.
Light 7.2 gal., 36 min.
This cycle is for lightly soiled china and crystal.
RINSE ONLY Heavy 2.9 gal., 7 min.
Light 1.4 gal., 3 min.
For rinsing partial loads that will be washed later. Do not use detergent with this cycle.
NOTE:
This dishwasher is equipped with an ExtraClean™Sensor with automatic temperature
control; therefore cycle length and time may vary depending on soil and temperature conditions.
NOTE:
Only the Anti-Bacteria cycle has been designed to meet the requirements of Section 6,
NSF 184 for soil removal and sanitization efficacy.
Extras
The light above the selected pad will be ON to indicate which EXTRA has been selected.
EXTRA For use with heavily soiled and/or dried-on, baked-on soils. This option
MUST
be selected
SCRUB
PRIOR
to starting the cycle.
This option adds 16 minutes to the cycle time. NOTE:
Cannot
(on some models) be selected with
RINSE ONLY
cycle.
HEATED DRY Shuts off the drying heat option. Dishes air dry naturally and energy is saved. For faster air dry,
Light OFF
you can prop the door open after the
CLEAN
light illuminates.
HEATED DRY Turns the heater on for fast drying. This will extend the time to your wash cycle by 8 minutes
Light ON
for the
SPEED CYCLE
and 30 minutes for all other cycles.
NOTE:
Cannot be selected with
RINSE ONLY
cycle.
LOCK
You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a cycle.
Children cannot accidentally start dishwasher by touching pads with this option selected.
To unlock the dishwasher controls, press and hold the
HEATED DRY
pad for 3 seconds. To lock
the dishwasher, press and hold the
HEATED DRY
pad for 3 seconds. The light above the
LOCK
pad will turn off.
EXTRA When selected, the cycle will run longer with heating elements on to improve both wash and
HOT WASH dry performance.
NOTE:
Cannot be selected with
RINSE ONLY
cycle.
DELAY HOURS You can delay the start of a wash cycle for up to 8 hours (on some models). Press the
DELAY
HOURS
pad to choose the number of hours you want to delay the start of the cycle, then press
START/RESET
. The machine will count down and start automatically at the correct time.
Pressing
START/RESET
a second time will cancel the
DELAY START
selection.
NOTE:
If you forget to fully close the door a reminder signal will beep until you do so.
RESET To change a cycle after washing starts, touch the
START/RESET
pad to cancel the cycle.
The
START/RESET
light will flash while the water is pumped out if needed. This takes approximately 90 seconds. When the light stops flashing, the dishwasher can be reprogrammed and restarted.
GEAppliances.com
3
Loading...
+ 11 hidden pages