GE Tetra GEPSJB60 Installation Manual

®

Tetra

Power Supply Junction Box

GEPSJB60

Junction Box Features

• GEPSJB60 supports: GEPS12-60, GEPS12D-60U, GEPS24-80, GEPS24D-80U,
GEPS12-60U-NA, GEPS12SE-60U-NA, GEPS12-60U-GL, GEPS24-100U-NA,
GEPS24-100U-GL, GEPS24-100U-GLX

• Can be used on primary side of the Tetra Power Supply

• Suitable for dry or damp locations

BEFORE YOU BEGIN

Read these instructions completely and carefully.

WARNING/AVERTISSEMENT

RISK OF ELECTRIC SHOCK:

• Disconnect power at fuse box or circuit breaker before servicing or
installing product.

• Properly ground Tetra® power supply.

RISK OF FIRE:

• Use only Tetra® supply wire to make connection from Tetra® power
supply to Tetra® LED strip.

• Use only approved wire for input connection. Maximum size 14 AWG;
minimum 75C rated.

• Branch circuit limit of 15A.

• Follow all local codes.

RISQUES DE DÉCHARGES ÉLECTRIQUES

• Coupez l’alimentation électrique à la boîte de fusibles ou au
disjoncteur avant l’entretien ou l’installation du produit.

• Assurez-vous de correctement mettre à terre l’alimentation
électrique Tetra®.

RISQUES D’INCENDIE

• N’utilisez que le l d’approvisionnement Tetra® pour faire la
connexion entre l’alimentation Tetra® et la bande DEL Tetra®.

• N’utilisez que des ls approuvés pour les entrées/sorties de
connexion. La taille maximale 14 AWG; minimum 75C nominale.

• Respectez tous les codes locaux.

Installation Guide

Installation

Remove screw and lock washer and snap the top cover

1 2

off of the junction box.

Select a wire entry knock out location and carefully

remove metal plug. Install wire box tting and supply

wire and secure in place.

Trim ush with

power supply

edge

GEPS24-100U-GLX

power supply

Power supply

mounting tab is

inside junction box

AC input end of

Power supply mounting tab

is under junction box

For GEPS24-100U-GLX only: On the AC input end of
power supply, trim or grind sides of mounting tab ush
with power supply. Then slide junction box onto AC input
end of power supply and align mounting holes. Ensure
power supply mounting tab is inside the junction box.

Mount and secure Junction Box and Tetra Power Supply
using #6 or #8 screws and star-type lock washers in
both holes.

For all other power supplies: Slide junction box onto

3B3A

AC input end of power supply and align mounting holes.
Ensure power supply mounting tab is under the junction
box.

Connect AC line ground wire to Junction Box ground

54

screw.

Connect Tetra Power Supply to AC

6

line per instructions enclosed with
the power supply.

All trademarks are the property of their respective owners. Information provided is subject to
change without notice. All values are design or typical values when measured under laboratory
conditions. Current, powered by GE is a business of the General Electric Company.
© 2018 GE.

www.currentbyge.com SIGN108 (Rev 08/24/18)

Neatly fold wires within the Junction

7 8

Box and reattach cover with mounting
screw and washer. Tighten securely.

Conforms to the following standards:

Complete installation. Continue with
LED light engine connections.