r
FCC LICENSE REQUIREMENT
Donot transmit with your CBunit without an FCC(Federal Communication Commission) Class D Citizens Radio Service
License, or temporary permit.
Youmustapplyfora licensebymailinga completedFCCForm505to
the FCC, GETTYSBURG,PA. 17326.
At the time this User's Guide was published, no fee for Class D
Licenses was required. This is, of course, subject to change in the
future.
Youmay use Form 555-Bas a temporarypermitwhileyourregular
Form505applicationis beingprocessedbythe FCC. .
Transmittingwithouta license or temporary permitis illegal,but you
can listen to (or monitor) all channels without a license. You are
!
required to be familiar with and understand Part 95 of the FCC
Rules when transmitting.
General requirements foran FCC license are that you must be 18 or
over and a U.S. citizen. Anyone 12 or over in your household can
operate the CBas longas the FCCrulesand regulationsarefollowed.
YourFCC station license willshow your call "letters" (or "sign").
Five or more units may be operated under a single FCC station
license. Ifyou plan to have morethan fiveunits, specifyquantityon
FCCForm505. .
FORMS PACKED WITH CB
. FCC Form 505 license application.
. FCC Form 555-B temporary permit.
. FCC Rules and Regulations, Part 95.
SPECIFICATIONS
GENERAL
CHANNELS: AM-40 channels. PLL digital logic channel synthesizer
circuitry. 40 USB and 40 LSB channels.
POWER REQUIREMENT:Consumption - 34.5 watts. Currentdrain -
2.5 amps (Max at 12 watts PEP) at 13.8-volt DC.
POWER SUPPLY: 12 volts DC nominal (positive or negative ground),
or 120 volts AC
-60 Hz.
SEMICONDUCTORS: Integrated circuits, transistors, FET (field
effect transistor), diodes, and 2 crystal filters -one in the AM IF and
one in SSB IF.
Crystal filters differ from LC or ceramic filters in that they are more
selective and reduce unwanted incoming signals.
RECEIVER
f
MAX SENSITIVITY: .3uV AM, .2uV SSB (to produce 500mwAudio
Output Min.)
CLARIFIER RANGE: :t 1000-2200 Hz.
FREQUENCYCOVERAGE: 26.965to27.405 MHz,40 channelsAM,
and SSB 80 channels.
ADJACENT CHANNEL SELECTIVITY: Min 60 db.
IMAGE REJECTION: Better than 55 db.
IF FREQUENCIES: SSB: 10,695 MHz, AM. 1st: 10,695 MHz. 2nd:
0.455 MHz.
RF GAIN CONTROL: 25 db nominal.
AGC (less than 10db Audio change from 3 uV -10,000 uV RF):
Min. 70 db.
OPERATINGTEMPERATURE RANGE: -30° to +50°C. Thermister
controlledfrequencygenerating crystalstoreduce transmitfrequency
variation over wide temperature ranQe.
PA/AUDIO POWER OUTPUT at 10% THD: 3.5 watts.
INTERNAL BURNOUT PROTECTION:Componentfailureprotection
for min. of5 minutestransmittingwithopen,shorted,orlooseantenna.
MICROPHONE: Dynamic with push-to-talk switch, 500-ohm.
BUILT-IN SPEAKER: 8 ohms impedance, 60 x 90 mm (3'h") insize.
CONNECTORS: External speaker jack 3.5 mm (8 ohms impedance).
Two SO-239 type antenna receptacles to match PL-259 coax plug (50
ohms impedance). PA Speaker Jack 3.5 mm (8 ohms impedance).
12-volt DC power jack, separate power cable that allows
easy discon-
nect. MIC Jack. AC power jack.
TRANSMITTER
FREQUENCY RESPONSE~400 Hz to 2.5 kHz.
FREQUENCYCOVERAGE: 26.965to27.405MHz;40 channels AM,
and SSB 80 channels.
TRANSMIT POWEROUTPUT: 4 watts maximumas limitedby FCC
Regulations at 13.8 volts DC (PEP 12 watts max SSB).
MODULATION:Capableof 100%. Factorypre-set limit, 85-100%.
TRANSMITTED HARMONIC & SPURIOUS SUPPRESSION(below
carrier): Min.62 db.
FREQUENCY ACCURACY: :t.001%.
CARRIER SUPPRESSION: Better than 40 db.
UNWANTED SIDE BAND SUPPRESSION: Better than 50 db.
ALL MEASUREMENTS TAKEN AT 25°C NOMINAL
AND 13.8 VOLTS DC.
-
3