GE Spacemaker GTUP270EMWW, Spacemaker GTUP270GMWW, Spacemaker GTUP270EM, Spacemaker GTUP270270GM Dimensions And Installation Information
Dimensions and Installation Information (in inches)
For answers to your Monogram,
®
GE Profile™ or
GE® appliance questions, visit our website at
geappliances.com or call GE Answer Center®
service, 800.626.2000.
360328
GTUP270EM/270GM
GE® 27" Unitized Spacemaker® Washer and Dryer
Listed by
Underwriters
Laboratories
Specification Revised 2/11
Electrical Requirements:
GTUP270EM Electric Dryer – This appliance should be connected to an
individual, properly-grounded branch circuit with 120/240V or 120/208V
single-phase 60 Hz electrical service and should be protected by
30-amp time-delay fuses or circuit breakers KW Rating per voltage
(240/208). This appliance is manufactured with neutral connected to the
frame. Power cord should be purchased separately.
Note:
These appliances are not approved for 120-volt operation.
Gas Requirements:
GTUP270GM Gas Dryer – This appliance should be connected to an
individual branch circuit with 120-volt single-phase 60 Hz electrical service
and should be protected by 20-amp time-day fuses or circuit breakers.
This appliance is equipped with a 4-foot long flexible U.S. listed 20-amp
power cord to match a 20-amp receptacle.
Note:
Gas Rated input 20,000 BTU/HR. Factory equipped for natural gas. Tested
for LP gas. LP gas supply requires a conversion kit. Have a qualified gas
technician install a conversion kit before use.
Dryers must be exhausted to the outside.
Installation Information:
For complete information, see installation instructions packed with
the product.
theewndcnnfnkj
theewndcnnfnkj
theewnd
theewnd
theewnd
theewnd
theewnd
theewnd
theewnd
theewnd
theewnd
thee
thee
theewnd
theewnd
theewnd
35
35
35
theewndcnnfnkj
35
35
35
35
35
35
35
35
35
35
Floor line
Distance
from vent
to back 4-1/2"
27-3/5
Water
inlet-
cold
1" For leveling legs
33-18/25
30-17/20
26-4/5
30
75-1/2
33-18/25
26-4/5
30
30-17/20
37
75-1/2
1/2
21-5/16
8
Drain
20-
7/40
Floor line
Distance
from vent
to back 4-1/2"
27-3/5
Water
inletcold
1" For leveling legs
33-18/25
30-17/20
26-4/5
30
37
75-1/2
1/2
21-5/16
8
Drain
207/40
Dimensions and Installation Information (in inches)
360328
GTUP270EM/270GM
GE® 27" Unitized Spacemaker® Washer and Dryer
Listed by
Underwriters
Laboratories
Specification Revised 2/11
For complete information, see installation instructions packed with your dryer.
Ducting Materials:
For best performance, this dryer should be vented with 4" diameter all rigid metal exhaust duct. If rigid metal
duct cannot be used, then UL-listed flexible metal (semi-rigid) ducting can be used (Kit WX08X10077). In special
installations, it may be necessary to connect the dryer to the house vent using a flexible metal (foil-type) duct.
A UL-listed flexible metal (foil-type) duct may be used ONLY in installations where rigid metal or flexible metal
(semi-rigid) ducting cannot be used AND where a 4" diameter can be maintained throughout the entire length
of the transition duct. Please see installation instruction packed with your dryer for complete instructions when
using flexible metal (foil type) ducting.
Exhaust Length Calculation:
1. Determine the number of 90° turns needed for your installation. If you exhaust to the side or bottom of dryer,
add one turn.
2. The maximum length of 4" rigid (aluminum or galvanized) duct which can be tolerated is shown in the table.
A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated as a 90° elbow. A turn
over 45° should be treated as a 90° elbow.
Dryers must be exhausted to the outside.
Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed house floor (crawl
space), or into an attic, since the accumulated lint could create a fire hazard or moisture could cause damage.
Never terminate the exhaust into a common duct or plenum with a kitchen exhaust, since the combination of lint
and grease could create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc. The wall cap
must also be located at least 12" above the ground or any other obstruction with the opening pointed down.
Special Installation Requirements
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
• The dryer MUST be exhausted to the outside.
• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0" either side and rear
1" front and top
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
• Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area
equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in.
of open area equally distributed.
• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors.
• The installation must conform with the local codes, or in the absence of local codes, with the National Electric
Code and National Fuel Gas Code, ANSI Z223 for gas dryers.
Minimum Clearances other than Alcove or Closet Installation:
• Minimum clearances to combustible surfaces
0" either side and rear
1" front and top
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at ge.com
or call GE Answer Center® service, 800.626.2000.
GTUP270EM/GM DRYER EXHAUST LENGTH
4" DIA.
4"
4" DIA.
4" DIA.
2-1/2"
RECOMMENDED MAXIMUM LENGTH
Exhaust Hood Types
Recommended
No. of 90º
Elbows
Rigid
Metal
Rigid
Metal
56 F eet
46 F eet
34 F eet
32 F eet
0
1
2
3
42 F eet
36 F eet
28 F eet
18 F eet
Use only
for short
run installations
360328
GTUP270EM/270GM
GE® 27" Unitized Spacemaker® Washer and Dryer
Specification Revised 2/11
Features and Benefits
• 3.3 cu. ft. capacity washer
• 5.9 cu. ft. capacity dryer
• 3 wash/spin speed combinations - Speeds are matched to fabric type
for great clothes care
• 9 wash cycles - Cycles are designed to specifically handle various
fabrics and soils
• 5 wash/rinse temperatures - Select the right temperature for ideal
wash results
• Auto-load sensing with 5 water levels - Washer will automatically
measure the load size and add just the right amount of water
• Bleach and fabric softener dispensers - Solutions are automatically
mixed with wash water for clean, bright, soft-to-the-touch results
• Rotary-electronic controls (washer) - Simplify cycle selection
• Cycle status lights - Provide accurate cycle times
• Rotary-electromechanical controls (dryer) - Allow fast, easy cycle
selection
• Model GTUP270EMWW – White on white (Electric)
• Model GTUP270GMWW – White on white (Gas)
Loading...