GE GESMARTAIRE 106633, GESMARTAIRE 106653, GESMARTAIRE 106643, SmartAire 106633, SmartAire 106643 User Manual

GE SMARTAIRE™HEPA FILTER # 106773 / # 106743

GE SMARTAIRE™CARBON FILTER #106753

For Consumer Assistance Please Call: 1- 877-207-0923

106633
106643
106653

REPLACING THE FILTER CLEANING

INSTRUCTIONS - STORAGE

PRE-FILTER
CLEANING/REPLACEMENT
INSTRUCTIONS

1. Every 2-3 weeks, check the condition of the foam pre­filter.

2. Open the front door and remove the Pre-filter frame to
examine the pre-filter (fig. 3).

3. If the Pre-filter has a noticeable amount of dust, lint, or
particulate accumulation, wash it by hand in warm
soapy water. The pre-filter must be washed at least
every 30 days or more often as necessary. If the pre-fil­ter is worn or damaged, replace it (go to step 5.). DO

NOT wash in an automatic washer, gently hand wash
only.

4. After washing, rinse and dry the pre-filter thoroughly
before replacing it into the air purifier door. DO NOT

dry the pre-filter in an automatic dryer, hand dry only
by dabbing gently with a dry cloth towel.

5. Replace pre-filter in door and latch pre-filter frame
(fig.3).

CAUTION: DO NOT OPERATE AIR PURIFIER WITH-

OUT A PRE-FILTER IN PLACE. DIRT AND LINT
WILL CLOG IT AND REDUCE PERFORMANCE.

STORAGE INSTRUCTIONS

If your air purifier will not be used for an extended
period of time, please follow the below instructions.

1. Turn unit off and unplug.

2. Clean Pre-filter and dry completely. See Pre-filter
cleaning instructions.

3. Remove Carbon and HEPA filters and discard.

4. Wipe air purifier clean as in cleaning instructions.

5. Replace Pre-filter.

6. Replace air purifier in original carton and store in a
dry cool place.

7. Order Replacement filters for next use.

REPLACING THE FILTERS

1. On average, HEPA filters need to be replaced every 12 ­18 months. Carbon filters need to be replaced every 3

- 6 months. Filter life will vary depending on air quality
and usage. Replace filters if punctured.

2. Turn off and unplug the air purifier before attempting
to replace the filters.

3. Remove each of the filters from the unit by pulling gen­tly towards you.

4. To replace the carbon filter, simply remove the old car­bon filter and insert a new carbon in its place, using
the plastic tabs as a guideline. (See Fig.1)

5. To replace the HEPA filter, discard the old HEPA fil­ters. Put a new carbon filter on the HEPA filter. Insert
the new HEPA filter into the unit, by sliding it onto the
hang tabs. (See Fig. 2)

6. After replacing the HEPA filters, RESET the filter life
monitor by inserting a small object (such as a pin or
paper clip) into the hole marked RESET.

NOTE: Carbon and HEPA filters are not washable and
should be replaced at the recommended intervals.

Figure 3

Figure 2

A. Pre-Filter Frame
B. Foam Pre-Filter

A

B