GE SCB2001F Specification
SCB2001F – Advantium™Wall Oven
Dimensions (in inches)
TM
R
Listed by
Underwriters
Laboratories
For answers to your Monogram,® GE Profile™or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
Specification Revised 11/03
240430
Most 30" Wall Cabinets can be used with this unit.
Cutout width
28-1/2
30
Required
cutout location
36-3/4"
minimum
from floor
Junction
box
location
A=Allow 1" overlap of oven over top and bottom edges of cutout.
B=Allow 11/16"-3/4" for overlap of oven over side edges of cutout.
4-3/16
21
Cutout height
A
B
19
Cutout depth
29-25/32
21-7/8
15-27/32
Excluding
Handle
Construct Solid
Bottom Min.
3/8" Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides.
(Must Support
150 lbs.)
Note: Cabinets installed adjacent to wall ovens must have an adhesion
spec of at least 194°F temperature rating.
Note: 2" minimum between cutouts when installed above warming
drawer or single wall oven.
TM
SCB2001F – Advantium™Wall Oven
36-3/4" Min.
Required
30"
19"
Min
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides
28-1/2"
21"
36-3/4" Min.
30"
24"
Min.
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides
2" Min.
Install 2 x 4
or 2 x 2
Runners or
Solid Bottom,
Must Support
100 lbs.
28-1/2"
21"
9-1/4"
*45-1/4"
30"
24"
Min.
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides
2" Min.
Per Oven
Requirement
28-1/2"
21"
Single Speedcook Installation
Order a 30" wide single oven cabinet or cut the opening
in a wall to dimensions shown.
The rough opening must be:
• Depth – 19" Min.
• Width – 28-1/2" Min.
• Height – 21" Min.
• 36-3/4" from the floor to the cutout is required.
• These ovens require 3/4" overlap on each side, top and
bottom of the cutout.
• Oven overlaps will conceal cut edges on all sides of
the opening.
Specification Revised 11/03
240430
Note: Additional clearance between the cutouts may be
required. Check to be sure the oven supports above
the Warming Drawer location does not obstruct the
required interior 23-1/2” depth and 9-1/4” height.
See installation instructions for details.
Speedcook Oven Installation above a single
GE Built-In Wall Oven
Speedcook Oven Installation above a
GE Warming Drawer
R
Listed by
Underwriters
Laboratories
For answers to your Monogram,® GE Profile™or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
Loading...