GE SCB2000FBB03, SCB2000FCC03, SCB2000FWW03, SCB2001KSS01, SCB2001KSS02 Installation Guide

Advan tium T_"

Built-In

Speedcook Ovens

Installation

Instructions

SCB2000, SCB2001

ZSC2000, ZSC2001

gefl_re w)u begin -- Read these instructions completely and carefllllv.
IMPORTANT - Save these insti_uctions fl_r local inspector's use.

IMPORTANT - OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer - Be StlYe to leave these instructions with tile ConStllIlei _.

Note to ConS/llIlei" - Keep these instructions with your Owners Manual lot fllture relerence.

WARNING: This appliance must be properly grounded. See "Electrical Requirements," page 5

Con>n

If vou received a damaged Oven, you should

immediately contact w)ur dealer or builder.

Proper installation is tile responsibility of tile
installer. Product tailure due to improper

installation is not covered under tile GE
Appliance Warranty. See tile Owners Manual

tot warranty information.

• Use this appliance only fin" its intended
purpose.

CAUTI ON:

• This oven should be installed by a qualified
installer or seiwice technician.

• Never use tile oven ti)r warming or heating a
room. Prolonged use of tile oven without
adequate ventilation call be hazardous.

Design Information

Product Dimensions ......................................... 3

Advance Plamfing ............................................ 3

Tools and Materials Required ......................... 3

For Monogram local service in your area,

1-800-444-1845.

For Monogram service in Canada, call

1-888-880-3030.

For Monogram Parts and Accessories, call

1-800-626-2002.

Check with local utilities for electrical codes
that apply in your area. Local codes vary.

Installation electrical comaections and
grounding must comply with applicable codes.

In tile absence of local codes, tile oven should
be installed in accordance with National

Electrical Code ANSI/N FPA 70 or latest
edition.

Cabinetry

Prepare tile Opening ....................................... 4

Single Installation ........................................... 4

Installed Above a Single Oven ........................ 4

Installed Above a Warming Drawer. ............... 4

Installation Preparation

Electrical Requirements ................................. 5

Install Junction Box ......................................... 5

Installation

Step ] : Remove Packaging and Parts .............. 6

Step 2: Route Conduit Through (_utottt ........ 6

Step 3: Secure Oven to Cabinet ...................... 6

Step 4: Comaect Electrical .............................. 7

Design Information

Buill-I_ Speedcook Ove_,_

Product
Dimensions

28-7/16-- [--(Recessed

/

/ Portion)

15"

15-27/32_.._25/32"_JJ

Models ZSC2001,ZSC2000

28-7/16'_'_( ReCr_iS0Sn_d__

15-27/32q _ 29-25/32''_

27/32"_

20-27/32" D -...

21-7/8"

_27/32" "',

[

7/8" 15/32"4_11/16"

15"

22-3/8"

7/8"

27/32"_

*. 14-1/8"_

,_ qL 1-1/16"

V _

20-27/32" D "'".

_27/32"

,

::::::::7_zA

15/32"41_11/16"

Advance
Plannin, g

oots and

MatoiaLs

Required

ModelsSCB2001,SCB2000

• These ovens may be installed directly into a
wall or wall oven cabinetry, 30" rninirnurn

width.

• Tire fl'ont surlhce of tire oven will be nearly
flush with surrounding cabineti T doors.

• This oven can be installed over any GE/
Monogram single electric built-in oven or a

single (;E/Monogram electric built-in

warrning drawer.

• This oven rnust be installed at least 36" above
tire floor.

Tools and Materials Required:

• 2 x 4 or 2x 2 lumberfor runners
" Saw
* Level
, Drill and 3/32" bit

, Phillips screwdriver

• Wood screws andadhesiveor other hardware for installing
runnersor shelfto supportoven.

IMPORTANT: This oven is not approved
J()i" use above another built-in Speedcook
oven, side bv side or under tire countertop

installations.

• For personal salety, this oven cannot be
installed in a cabinet arrangernent such as an

island or peninsula.

• Cabinets installed ac!jacent to wall ovens rnust
have an adhesion spec of at least 194°F

temperature rating.

• Allow tor clearance to ac!jacent corners, walls,
ch'awei's, etc.

Electrical Requirements

• Junction box

• Electrical cable -3-conductoror 4-conductor wire, as required
by local codes.

• ULlisted conduit connector

• Wire cutters and wire stripper