0
Profi/e/ r nce Seri
SCB2000CBB- Advantium Wall Oven
Dimensions (in inches)
18"
15-27/32"_25/32 _
*Excludinghandle
7/8" 15/32" 4_r11/16"
27/32'4]_
14-_[_ 9/16"
20-27/32" _ "',,
27/32" ',
13"_
Electrical Requirements
Single SpeedcookInstallation
Productrating is120/208or 120/240volt,60 Hz,30Amps.Thisproductmustbeconnectedto asupplycircuit
ofthe propervoltageandfrequencyandprotectedbya timedelayfuseor circuitbreaker.Thepowersupply
shouldbebroughtto a separate30amperebranchcircuit.Wire sizemustconformto the requirementsofthe
NationalElectricCodeorthe prevailinglocalcode.
CombinedSpeedcookand Wall OvenInstallation:
When installed in combination with a GEsingle wall oven, useseparate electrical iunction boxes,
OR,
Install a single junctionbox connected to 50 amp.supply circuit or properly rated supply circuit.
• Referto single oven installation instructions for electrical requirements of
that product.
• These connections must be made by a qualified electrician. All electrical
connections must meet National Electrical code or prevailing local codes.
CombinedSpeedcookand Warming Drawer installation:
When installing the Speedcook oven over a GEelectric warming drawer, a separate 120V,6OHz,
properly grounded receptacle must be installed. See instructions packed with the warming drawer.
Installation Requirements
• These ovensmay be installed directly into a wall orwall oven cabinetry,
30"minimum width.
• The front surface of the ovenwill be nearly flush with surrounding cabi-
netry doors.
• This ovencan be installed over any GEsingle electric bugt-in oven or a
single GEelectric bugt-in warming drawer.
• This ovenmust beinstalled at least 36"above the floor.
IMPORTANT:This oven is not approved for use above another
built-in Speedcook oven, side by side or under the countertop
installations.
• For personal safety,this oven cannot beinstalled in a cabinet arrange-
ment such as an island or peninsula.
•Cabinets installed adiacent to wall ovens must have an adhesion spec of
at least 194°Ftemperature rating,
•Allow for clearance to adjacent corners, walls, drawers, etc.
Foranswersto yourMonogram_
GEProfilePerformanceSeriesl"
GEProfileTM or GEappliancequestions,call
GEAnswerCentePservice,800.626.2000.
SpecificationRevised10/00
UnderwUters
Listedby
Laboratories
0
Profi/e/ r nce Seri
SCB2OOOCBB- AdvantiumTM Wall Oven
Single SpeedcookInstallation SpeedcookOvenInstallationabovea
GEWarmingDrawer
ConstructSolid
BottomMin.3/8"
2x4orlx2
Runners,all
FourSides
363/4"Mir
Required
Order a30"wide single oven cabinet or cutthe opening
in awall to dimensions shown.
The rough opening mustbe:
• Depth - 19"Min.
• Width - 28-1/2"Min.
• Height - 21"Min.
• 36-3/4"fromthe floor to the cutout is required.
• Theseovens require 3/4"overlap on each side,top and
bottomof the cutout.
• Oven overlapswill conceal cut edges on all sides of
the opening.
SpecificationRevised10/00
Note: Additional clearance between the
cutouts may be required. Checkto be sure
the oven supports above the Warming
Drawer location does not obstruct the
required interior 23-1/2" depth and 9-1/4"
height. Seeinstallation instructions for
details.
ConstructSolid
BottomMin.3/8"
Plywood
Supportedby
2x4or1 x2
Runners,all
FourSides
or2x2
Runnersor
SolidBottom,
MustSupport
100Ibs.
SpeedcookOvenInstallationabovea single
GEBuilt-In Wall Oven
ConstructSolid
BottomMin.3/8"
Plywood
,Supportedby
2x4orlx2
Runners,all
FourSides
PerOven
Requirement
Foranswersto yourMonogram?
GEProfilePerformanceSeriesl"
GEProfileTM or GEappliancequestions,call
GEAnswerCenter_service,800.626.2000.
(_ Listedby
Underwdters
Laboratories