GE SCA2001KSS Specification

66" MIN.

Mounting

height from

floor

30"

MIN.

width

required

Exhaust outlet

connects to

3-1/4" X 10" duct

16-13/32

(Rear)

15-1/4

29-7/8

12"

MIN.

30 amp

Disconnect Switch

NEMA 14-30R

Wall Receptacle

SCA2001KSS – Above-the-Cooktop Advantium™ Oven

Dimensional Information (in inches)

IMPORTANT: PLEASE READ CAREFULLY. FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED TO AVOID SEVERE OR FATAL SHOCK.

Note: Outside venting is optional. Vent (duct) can be horizontal or vertical.

Specification Created 9/05

240435

Insure proper ground exists before use.

Installation Information: This information is not intended to be used for installing unit described. Before installing, consult installation instructions packed with product/kit for current dimensional data.

Listed by Underwriters Laboratories

For answers to your Monogram,® GE Profile™ or GE appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT, DEFORM, OR REMOVE ANY OF THE PRONGS FROM THE POWER CORD. DO NOT USE WITH AN EXTENSION CORD.

NEMA 14-30R Wall Receptacle

SCA2001KSS – Above-the-Cooktop Advantium™ Oven

Hood Exhaust Duct

Outside ventilation requires a HOOD E XHAUST DUCT. Read the following carefully.

EXHAUST CONNECTION: The hood exhaust has been designed to mate with a standard 3-1/4" x 10" rectangular duct.

If a round duct is required, a rectangular-to-round transition adaptor must be used. Do not use less than a 6" diameter duct.

REAR EXHAUST: If a rear or horizontal exhaust is to be used, care should be taken to align exhaust with the space between studs, or wall should be prepared at the time it is constructed by leaving enough space between the wall studs to accommodate exhaust.

Filter Kit Accessory

Filter Kit

JX81A–Recirculating Charcoal Filter Kit

To be used when the Advantium oven

Grille

cannot be vented to the outside.

MAXIMUM DUCT LENGTH: For satisfactory air movement, the total duct length of 3-1/4" x 10" rectangular or 6" diameter round duct should not exceed 140 equivalent feet.

ELBOWS, TRANSITIONS, WALL AND ROOF CAPS, etc., present additional resistance to airflow and are equivalent to a section of straight duct which is longer than their actual physical size. When calculating the total duct length, add the equivalent length of all transitions and adaptors plus the length of all straight duct sections. The chart below shows the approximate feet of equivalent length of some typical ducts.

Duct

Rectangular-To-round

Equivalent Feet

5 ft.

Transition Adaptor

Wall Cap 40 ft.

90° Elbow 10 ft.

45° Elbow 5 ft.

90° Elbow 25 ft.

45° Elbow 5 ft.

Roof Cap 24 ft.

Specification Created 9/05

240435

Listed by Underwriters Laboratories

For answers to your Monogram,® GE Profile™ or GE appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000.

+ 1 hidden pages