GE RAVHW1, RAVHW2, RAVHW3 Installation Guide
TOOLS NEEDED
• Adjustable wrench
• Phillips head screwdriver
• Brazing equipment
• Piping solder or flux
B] Connect the tubing.
There are two options: [] Standard Connection or
[] By-Pass Connection.
Choose the appropriate connection for your
installation requirements.
.4,CAUTION: Disconnect the electricalpower
supplg before installing.
Fll Placethe Heater the Vertical
Zoneline by locating the four holes in its side
flanges over the four bolts on the top of the
Zoneline.
HL!dronic
heater
bolts
Zoneline
F21 Attach Hydronic Heater to using
6 screws.
Hydronic
the the Zoneline
onto
,
Locating
holes (_nd
bolts
I
Standard Connection Option
Connect the 90°elbow to the upper outlet tube.
Connect the shut-off valve to the other end of the
90°elbow.
Shut-off
valve
90°
elbow
tube
FB1 By-Pass Connection Option
Connect the long two-bend tube to the lower inlet
tube, turn it and connect it to the T-fitting inthe
outlet tube. Connect the shut-off valve to the other
end of the T-fitting.
Shut-off
valve
31-61420 I
07-07 JR
T-fitting
two-bend
tube
Lower inlet
tube
Printed in Chino
Installation Instructions
14"1 Connect the from the
Hgdronic Heater to the three-pin connector
on the Zoneline.
three-pin
connector
U
Three-pin _\
connectors
I-'S1 Runand the !0" round duct the
Hgdronic Heater.
10" round
connect to
r61 Move the actuator switch to the OPENposition.
Actuator
rT1 Reconnect electrical power.
OUTILLAGE NECESSAIRE
• CI__ molette • Equipement de brasage
• Tourneviscruciforme • Brasure ou flux de tugauterie
B] Raccordez la tugauterie.
IIexiste deuxoptions: [] Raccordementnormalou
[] Raccordementavecderivation.
¢hoisissez le raccordement appropri_ aux
conditions requises de votre installation.
IkATTENTION :D branchez,'alimentation
_lectrique avant installation.
r_ Placez g_n_rateur chauffage sur
G_n@roteur
de chQuffage
centrQI
Emplucement
des trous et
des boulons
Zoneline
F2-1 Fixez g_n_rateur chauffage sur
le de central
le Zoneline vertical en faisant colncider les quatre
trous des collerettes lat_rales sur les quatre
boulons sup_rieurs du Zoneline.
Emplucement
des trous et
des boulons
le de central
le Zoneline _ I'aide de 6 vis.
I
Option de raccordement normal
Raccordez le coude _ 90° au tugau de sortie
sup_rieur. Raccordez la vanne defermeture
I'autre extr_mit_ du coude _90°.
W]nne de
fermeture
Coude
90°
sup_rieur
Option de raccordement avec d_rivation
Raccordez le long tugau _ deux coudes au tugau
d'entr_e inf_rieur, tournez-le et raccordez-le au
raccord en T du tugau de sortie. Raccordez la vanne
de fermeture _ I'autre extr_mit_ du raccord en T.
Wnne de
fermeture
RQccorden T
Tug(]u d'entr_e
0 deux
coudes
inf_rieur
3
Loading...