GE RAK148F2, RAK164F2 Owner's Manual And Installation Instructions
SAFETY INFORMATION .............................. 2
OVERVIEW............................................................... 3
INSTALLATION ............................................. 4–7
CONFIGURATION MODE ........................ 8, 9
OPERATING FUNCTIONS ....................... 10
TESTING THERMOSTAT ...................11–12
TROUBLESHOOTING ................................... 13
WARRANTY ......................................................... 16
THERMOSTAT
Digital Non-Programmable
OWNER’S MANUAL &
INSTALLATION INSTRUCTIONS
RAK148F2
RAK164F2
LIA319 9-7757 05-16 GEA
2
Specifications.
WARNING
FIRE AND SHOCK HAZARD
• Always turn off power at the main power supply
before installing, cleaning or removing the
thermostat. Failure to do so could result in
electrical shock hazard.
• Do not use on voltages over 30 VAC. Higher
voltages will damage the thermostat and could cause
shock or fire hazard.
NOTICE
• All wiring must conform to local and national
electrical and building codes.
• Use this thermostat only as described in this
manual.
Electrical rating: • 24 VAC (18–30 VAC)
• 1 amp maximum per terminal
• 4 amp maximum total load
Operating temperature range: 40°F–99°F (4°C–37°C)
Temperature set range: 60°F–85°F (15°C–29°C)
Accuracy: ± 1°F (± 0.5°C)
System configurations:
RAK148F2: 2-stage heat (heat pump/resistance heat), 1-stage
cool, 2-speed fan
RAK164F2: 1-stage heat (resistance heat), 1-stage cool,
2-speed fan
Terminations: R, C, W, Y, GH, GL, B (RAK148F2);
R, C, W, Y, GH, GL (RAK164F2)
Wiring:
Maximum wiring length is 66ft (20 meters) for
AWG18
Maximum wiring length is 60ft (18 meters) for
AWG20
IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING
PARTS DIAGRAM
INTRODUCTION OVERVIEW
3
THERMOSTAT CONTROL
Auto
Cool Off
Heat
On
Low High
Display Up/Down Buttons
Function Switch
Fan Auto/On Switch
B GH GL Y W C
R
COOL OFF
HEAT
RESETRIGHTLEFT
AUTO ON
HIGH
LOW
Display
Up/Down Buttons
Wiring
Channel
Mounting
Hole
Function
Switch
Fan Auto/On
Switch
Mounting
Hole
Configuration
Buttons
Fan Speed Switch
Fan Speed
High/Low
4
INSTALLATION INSTRUCTIONS
WARNING
ELECTRICAL SHOCK HAZARD—Turn off
power by unplugging the unit or by removing
the fuse or switching the appropriate circuit
breaker to the OFF position before removing
the existing thermostat. Failure to do so could
result in risk of electric shock.
PACKAGE CONTENTS/
TOOLS REQUIRED
Package includes: Thermostat on base, thermostat
cover, wiring labels, screws and wall anchors.
Tools needed: 'ULOOZLWKƎELWKDPPHUVFUHZGULYHU
and putty.
5
TO REMOVE EXISTING THERMOSTAT
1. Turn off power to heating and cooling system by
removing the fuse or swi tching off the appropriate
circuit breaker.
2. Remove cover of old thermostat. This should expose the
wires.
3. Label the existing wires with the enclosed wire labels
before removing wires.
4. After labeling wires, remove wires from wire
terminals.
5. Remove existing thermostat base from wall.
6. Refer to the following section for instructions on how
to install this thermostat.
INSTALLATION INSTRUCTIONS
Loading...