GE PSW26MSR, PSW26PSRSS, PSW26MSRSS User Manual

"94 SxS Refer

Top View

PSW26MSR – GE Profile Arctica® ENERGY STAR® 25.6 Cu. Ft. Stainless-Wrapped

Side-By-Side Refrigerator with Dispenser

Dimensions (in inches)

Specification Revised 7/05

210399

70-3/4*

68-3/4

32-1/4

34-11/16

50-4/7

36**

36-1/4

1/8

Height to top of hinge (in.) A

Height to top of case (in.) B

Case depth without door (in.) C

Case depth less door handle (in.) D

Case depth with door handle (in.) E

Overall

Dimensions

Depth with fresh food door open 90° (in.) F

Width (in.) G

Width with door open 90° with door handle (in.) H

Each side (in.)

Top (in.)

Air

Back (in.)

Clearances

**When cap is removed: 69-1/4".

**Width including caps is 36-3/16".

†

† Water hook-up fits in back air clearance when calculating installation depth. If installed against a wall, allow clearance of 14-3/16" on freezer side to remove ice bin. To remove fresh food pans, remove door bins. Clearance required to remove fresh food full-size pan without disassembling: 18-15/16". Plus, allow additional space for any necessary leveling adjustments.

Total volume and shelf area are calculated by the Association of Home Appliance Manufacturers’ standards.

As an ENERGY STAR® partner, GE has determined that this product meets the ENERGY STAR guidelines for energy efficiency.

For answers to your Monogram,® GE Profile™ or

Listed by Underwriters Laboratories

GE® appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000.

Water Line Coupler

Hinge Screws

Wire Harness

Toekick Screw

PSW26MSR – GE Profile Arctica® ENERGY STAR® 25.6 Cu. Ft. Stainless-Wrapped

Side-By-Side Refrigerator with Dispenser

To Remove Top Cap and Doors on PSW26MSR

Step 1: Locate and remove two Phillips head screws on the top of

the refrigerator. Remove two screws, one on each side at the rear of the top cap. Lift off and remove top cap.

toekick. Pull forward to remove toekick.

pushing against the collar on the left side. Disconnect wire harness.

top hinge. Carefully remove hinge while supporting door. Lif t door up and off bottom hinge. Remove fresh food door in the same manner. Note: Do not remove bottom hinges! Door alignment will be difficult if bot tom hinges areremoved.

side. Move refrigerator to the installation location.

the tubing and electrical connector through the bottom hinge. Reinstall top hinges.

original screws in the top and back of the cap.

Step 2: Open both doors. Remove one screw on each side of the

Step 3: On the freezer door, disconnect water line coupler by

Step 4: Use a Torx T-20 screwdriver to remove 2 screws holding the

Step 5: Place refrigerator onto a hand truck, upright and against one

Reinstall Doors, Top Cap

Step 6: Carefully lower doors onto bottom hinges. Be sure to route

Step 7: Place cap over the top of the refrigerator. Reinstall the

Step 8: Reconnect the wiring harness and waterline.