GE PSW23PSRSS, PSW23PSR User Manual

PSW23PSR – GE Profile Arctica CustomStyle™ ENERGY STAR® 22.6 Cu. Ft. Stainless-Wrapped

"94 SxS Refer

Top View

Side-By-Side Refrigerator with Dispenser

Dimensions (in inches)

Specification Revised 7/04

210265

69-1/4*

68-3/4

23-7/8

26-3/4

29-3/16

45-9/16

35-3/4*

38-3/16

1/8

1/2

Height to top of hinge (in.) A

Height to top of case (in.) B

Case depth without door (in.) C

Case depth less door handle (in.) D

Case depth with door handle (in.) E

Overall

Dimensions

Depth with fresh food door open 90° (in.) F

Width (in.) G

Width with door open 90° with door handle (in.) H

Each side (in.)

Top (in.)

Air

Back (in.)

Clearances

*Width including top caps is 36-3/16".

†

† Water hook-up fits in back air clearance when calculating installation depth. If installed against a wall, allow clearance of 13-15/16" on freezer side to remove ice bin. To remove fresh food pans, remove door bins. Clearance required to remove fresh food full-size pan without disassembling:

18-5/8 Plus, allow additional space for any necessary leveling adjustments.

Total volume and shelf area are calculated by the Association of Home Appliance Manufacturers’ standards.

For answers to your Monogram,® GE Profile™ or

Listed by Underwriters Laboratories

GE GEAppliances.com or call GE Answer Center

appliance questions, visit our website at

As an ENERGY STAR® partner, GE has determined that this product meets the ENERGY STAR for energy efficiency.

service, 800.626.2000.

guidelines

PSW23PSR – GE Profile Arctica CustomStyle™ ENERGY STAR® 22.6 Cu. Ft. Stainless-Wrapped

Water Line Coupler

Hinge Screws

Wire Harness

Toekick Screw

Side-By-Side Refrigerator with Dispenser

To Remove Top Cap and Doors on PSW23PSR

Step 1: Locate and remove two Phillips head screws on the top of

the refrigerator. Remove two screws, one on each side at the rear of the top cap. Lif t off and remove top cap.

Step 2: Open both doors. Remove one screw on each side of the

toekick. Pull forward to remove toekick.

Step 3: On the freezer door, disconnect water line coupler by

pushing

against the collar on the left side. Disconnect

wire harness.

Step 4: Use a Torx T-20 screwdriver to remove 2 screws holding the

top hinge. Carefully remove hinge while supporting door. Lif t door up and of f bottom hinge. Remove fresh food door in the same manner. Note: Do not remove bottom hinges! Door alignment will be difficult if bottom hinges are removed.

Step 5: Place refrigerator onto a hand truck, upright and against one

side. Move refrigerator to the installation location.

Reinstall Doors, Top Cap

Step 6: Carefully lower doors onto bot tom hinges. Be sure to route

the tubing and electrical connector through the bottom hinge. Reinstall top hinges.

Step 7: Place cap over the top of the refrigerator. Reinstall the

original screws in the top and back of the cap.

Step 8: Reconnect the wiring harness and waterline.