GE Profile PSHW6YGZ, Profile PSHW6YGZSS Dimensions And Installation Information

Listed by
Underwriters
Laboratories

As an ENERGY STAR

®

partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.

For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,

800.626.2000.

Specification Revised 8/10

210306

Overall

Dimensions

Height to top of hinge (in.) A 69-1/4*

Height to top of case (in.) B

68-3/4

Case depth without door (in.) C

†

28

Case depth less door handle (in.) D

†

32-3/8

Case depth with door handle (in.) E

†

35

Depth with fresh food door open 90° (in.) F

†

50-1/8

Width (in.) G

36

Width with door open 90° inc. door handle (in.) H

43-1/2

Air

Clearances

Each side (in.)

1/8

Top (in.)

1

Back (in.)

1

PSHW6YGZ

GE Profile™ ENERGY STAR® 25.6 Cu. Ft. Stainless-Wrapped Side-by-Side Refrigerator

Dimensions and Installation Information (in inches)

*When cap is removed: 69-1/4"
† Water hook-up fits in back air clearance when calculating

installation depth.

If installed against a wall, allow clearance of 14-3/16" on freezer
side to remove bin.

Clearance required to remove fresh food full-size pan without
disassembling is 18-15/16".

Allow additional space for any necessary leveling adjustments.

A

Top View

G

D

C

F

B

E

H

For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,

800.626.2000.

Listed by
Underwriters
Laboratories

As an ENERGY STAR

®

partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.

Specification Revised 8/10

210306

To Remove Top Caps and Doors on PSHW6YGX

Step 1: the refrigerator. Remove two screws, one on each side at the rear of the top
cap. Lift off and remove top cap.

Step 2: Open both doors. Remove one screw on each side of the toekick. Pull forward
to remove toekick.

Step 3: On the freezer door, disconnect water line coupler by pushing against the collar
on the left side. Disconnect wire harness.

Step 4: Use a Torx T-20 screwdriver to remove 2 screws holding the top hinge. Carefully
remove hinge while supporting door. Lift door up and off bottom hinge. Remove fresh
food door in the same manner. Note: Do not remove bottom hinges! Door alignment
will be difficult if bottom hinges are removed.

Step 5: Place refrigerator onto a hand truck, upright and against one side.
Move refrigerator to the installation location.

Step 6: Carefully lower doors onto bottom hinges. Be sure to route the tubing and
electrical connector through the bottom hinge. Reinstall top hinges.

Step 7: Place cap over the top of the refrigerator. Reinstall the original screws in the top
and back of the cap.

Step 8: Reconnect the wiring harness and waterline.

Water Line Coupler

1.

Hinge Screws

Wire Harness

Toekick Screw

4.

3.

2.

PSHW6YGZ

GE Profile™ ENERGY STAR® 25.6 Cu. Ft. Stainless-Wrapped Side-by-Side Refrigerator