GE MGA Specification Sheet

Page 1
GE
INDOOR LIGHTING
g
Lighting Solutions
GUIDE FORM SPECIFICATIONS MINI•GARDTM FLUORESCENT LUMINAIRE
ENCLOSED AND GASKETED
GENERAL DESCRIPTION
The complete luminaire designated ________ (identify) shall be a GE MINI.GARDTM fluorescent luminaire, ordering number ________ (specify MGA, plus ordering number logic from cata­log or approved equal, to operate ________ (specify one [13 or 26] watt or two 26-watt fluorescent) lamp(s) from a nominal ________ (specify 120, 277, or 347) volt, 60 Hertz power source and shall be capable of starting and operating the specified lamp within the limits specified by the lamp manufacturer. The luminaire shall contain a completely prewired integral ballast and optical assembly suit­able for continuous service, either indoors or outdoors, in an ambient temperature of 40 degrees C. Standard construction is IP55. The luminaire shall be UL Listed SUITABLE FOR WET LOCATIONS and UL Listed to Canadian National Standards and Codes for Indoor/ Outdoor Locations.
MECHANICAL CONSTRUCTION
For ease of installation and to facilitate maintenance and re­placement, the MGA luminaire shall be supplied as components
- ballast, mounting, optical and accessories. A lamp shall be included but shall not be installed.
The luminaire shall include a die-cast low copper aluminum housing with electro-epoxidized gray paint finish inside and outside. All external hardware shall be stainless steel. There shall be provision for a ballast safety chain.
The luminaire shall be ________ (specify ceiling, flexible pen­dant , angle stanchion, pendant, straight stanchion or wall) mounted. A stainless steel closure screw in the ballast housing shall mate with a polymer coated insert in the mounting com­ponent.
OPTICAL ASSEMBLY
The optical assembly shall include a ________ (specify large glass globe with or without Maxi-Lux® guard). The optical as­sembly shall also include as an accessory ________ (specify no reflector or dome, deep dome or angle dome reflector).
External reflectors shall be aluminum with a chemically bonded lightweight non-breakable ALGLAS surfaces for corrosion resistance.
The Maxi-Lux guard shall be of inverted design for improved photometric performance.
The optical assembly shall contain a compact double biaxial socket for fluorescent lamps. The 52-watt fluorescent unit shall have provision for two 26-watt lamps. The optical assembly shall be charcoal filtered.
®
finish on inside and outside
BALLAST OPERATION
The luminaire shall contain a standard ________ (specify HPF Reactor or NPF Reactor) type ballast* in full compliance with lamp-ballast specifications available to the fixture manufac­turer from the lamp manufacturers at the time of fixture manufacture.
The ballast shall reliably start and operate the lamp in ambient temperatures down to - 32°F.
* FOR MORE DEFINITIVE INFORMATION, REFER TO BALLAST SPECIFICATIONS IN TECHNICAL DATA SECTION.
Guide Form Specifications – 2011
Page 2
g
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com
1 6 9 4 3 5 3 3- - -- 8 8 8
GE Lighting Solutions is a subsidiary of the General Electric Company. Evolve and other trademarks belong to GE Lighting Solutions. The GE brand and logo are trademarks of the General Electric Company. © 2011 GE Lighting Solutions. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
Loading...