GE JXS80SS Installation manual

Take the backguard and hook the front into
the large slots in the cooktop. The vent trim was
hooked in this same way before you removed it .

3

Installation instructions

JXS80SS

for your new Backguard

Before you begin – Read these instructions completely and carefully.
IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer – Be sure to leave these instructions with the Consumer.
Note to Consumer – Keep these instructions with your Owner’s Manual for future reference.

TOOLS NEEDED

• 1/4″ Hex Driver, 1/4″ Open-End Wrench or 1/4″ Box Wrench

Backguard

This kit is used in an installation where the standard 25″
deep countertop has a backguard, and the countertop is
completely removed to the back wall.

31-21366

08-07 JR

Printed in the United States

30″

Remove the protective film that covers the
backguard (peel up from corner).

Remove 3 screws (one on each end and one in the
middle) holding the vent trim onto the range. Use a
1/4″ hex driver. Keep the screws for later use.

1

Back of range

Screws

Remove the vent trim by lifting the rear side and
pulling upward.

2

Vent
trim

Rotate the backguard into place. Make sure that
the center vent is clear upon installation.

4

Vent should
be clear

Cooktop

Slide the backguard panel under the top of the
backguard retaining tab. Using the three screws
removed earlier and the seven supplied screws,
screw down the backguard to the range using
the 1/4″ hex driver.

6

Back of range

Screw
locations

(WB36K10694)

Attach the backguard to the top of the cooktop
using four screws (two on each side).

5

Back of range

Screw
locations

Retaining
tab