GE JXS56WW Installation Guide

Installation Instructions

Adjust Range Height

Tighten

This

Assembly

Washer

Spacer

Plastic Leg Leveler

Metal Leg Leveler

36-3/4”-38” High Countertop Kit

Tools Required:

#2 Phillips screw driver 1 7/16” Adjustable wrench

Parts Suppled:

4 Modified Plastic Leg Levelers 4 Leg spacers 4 Washers 4 Metal Leg Levelers 2 Screws 1 Toe Plate

Installing the Kit for Slide-In Ranges

Prepare the location for the range by following the InstallationInstructions for a Slide-In Range.

The 4 extended leveling leg assemblies consist of the washer, leg spacers, modified plastic leg levelers and the metal leg levelers.

The following is the order of assembly:

a. Place the plastic leg leveler supplied in the kit through the hole in the

plastic leg spacer followed by the metal washer.

b. Remove the 4 existing leg levelers and replace with the 4

assemblies in (a).

c. With the adjustable wrench, slightly over hand tighten the

assemblies into the range base assembly.

d. Screw the metal leg levelers into the tapped holes in the end of the

plastic leg levelers.

e. Adjust the levelers so the glass and support flanges of the cooktop

clear the countertop.

Then follow the Slide-In Installation Instructions for proper installation of the range.

Install the Toe Plate

Put the toe plate in place.

Secure the toe plates in place using the

REMOVE STORAGE DRAWER

two screws supplied in the kit.

Pub. No. 31-10449

229C4053P432

TOE PLATE

2-SCREW ( 1-EACH SIDE )

ADJUST LEG LEVELER HEIGHT, FRONT & REAR